Home |
Search |
Today's Posts |
#11
![]() |
|||
|
|||
![]()
"Gould 0738" wrote in message
... .... Starting the boat with the battery charger running can disguise a weak battery. This is true, especially if your only way of measuring charge state is to look for 13.2 Volts, which gives you no information. By starting the engine on the battery you are performing an informal "load test." If you only use your boat infrequently, this is a good idea. BTW, if you use a battery combiner it will likely disconnect the starting battery from the charger when you start. If you use an echocharge, the starting battery is only seeing 10 amps from the charger. Turning on the battery charger once the engine is running will not, ordinarily, increase the rate at which the battery is being charged. See note below about proper wiring. This is generally true, though it depends on the component size. The "standard" configuration for my boat is two 9.9 hp outboards that only have 10 Amp alternators - they won't fill the charging capacity of the stock 425 Amp-hours of the main bank. There is an upper voltage limit on some of the regulators and controllers used to regulate charging from alternators, AC converters, or any other sources like wind or solar. In some 12-volt system cases, this is 26-28 volts. Whoa! What's that? My charger could put out 28 volts? Or are you saying they could be hurt by that much voltage? An alternator pumping out 14-15 volts and an AC converter doing the same could blow out some of these components. Are you claiming we have to add up all of the voltages of the various charge sources? If your boat is miswired so this could happen I would think you'd want to find out about it real quick! I have direct knowledge of an alternator that required a rebuild. According to the rebuild shop, the damage was "consistent with the things we see when people run their battery charger and their alternator at the same time." Sounds rather jaxian to me. Are you sure you understood what he said? What actually got damaged? I run two engines, each with an alternator, one of them capable of putting out 100 Amps. Why isn't this the same thing? Why aren't there hundreds of twin engine boats blowing alternators every day? You still haven't told us what you think will blow. If a boat is properly wired, there may be only minimal risk of screwing something up by running the alternator and the AC converter at the same time. A good portion of the new boats coming off the assembly lines and a likely majority of boats that have had any electrical cobbling done after manufacture are not properly wired. What kind of miswiring are you talking about? Isn't it more important to find those problems? When I worked as a broker, I would never start somebody else's boat with the shorepower running. Why risk it? If a boat wasn't going to start without the charger running, the time to address and correct that was *before* a prospective buyer came aboard. I suppose its always prudent to test the starting battery on a boat you've never taken out before. This is different from saying "you should not try to charge the battery from the charger and run the engine". |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Another deep cycle battery question...>>> | General | |||
Is it my battery or alternator that let me down? | General | |||
charging deep cycle trolling battery with truck | General | |||
Battery charging | General | |||
More Battery Questions | General |