About Us

genie, shut up.

Subject: Why need anchor chain?
From: Gene Kearns
Date: 9/18/2004 7:46 PM Eastern Daylight Time
Message-id:

On 18 Sep 2004 21:15:33 GMT, (JAXAshby) wrote:

What happens during the interaction of forces on the rode would be
most fascinating.

a way to simplified look at it is to consider the chain/rode/line to have
zero
weight pulled between two points (say 100 feet apart), then hang a 1# weight
in
the center point and check how much strain it put on the end points when the
weight hangs 20 feet, then 10 feet, then 5 feet, then 1 foot, then 1 inch,
then
1/10th inch. Just use trig to figure the forces.

So.... we just used intuitive trig to figure out why (1) we use scope
with an anchor and (2) why we don't tie boats to the dock with chain.
Now *that* is some real science......

And your "simplified look" does not apply.... an anchor rode does not
employ both ends at the same "Y" value.... therefore assumptions of
Y=Y'=0 do not obtain and is, therefore, the root cause of your lack
of understanding in this area. There isn't *anything* *attached* to
the middle.

the forces get out of hand ********VERY******** quickly. Even worse, is
that
the weight in the middle (or chain) has momentum as the boat rocks, so the
"natural" position of the weight overshoots and makes for seriously high
g-loads.

There is no weight "in the middle" (other than the weight of the rode)
.... so you put two anchors on the same rode? Odd.

Using that concept, most people use kellets and think it is a good and
useful idea.

--

Grady-White Gulfstream, out of Southport, NC.

http://myworkshop.idleplay.net/cavern/ Homepage
http://www.southharbourvillageinn.com/directions.asp Where Southport,NC
is located.
http://www.thebayguide.com/rec.boats Rec.boats
at Lee Yeaton's Bayguide

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Menu

About Us