About Us

On 6 May 2005 14:18:00 -0700, wrote:

I have a new to me '81 Mercruiser 228 5.0L. The dipstick tube has a
threaded fitting for a hose attachement that, I think, is there to suck
the oil out. I don't know if there is a plug on the oil pan or not.
I'd either have to remove my whole rear seat (possibly openning a huge
can of worms) or stand on my head in the engine compartment to find
out.

I know that they make hand pumps to get the oil out but I want to do is
hook up a hose to the dip stick tube with the other end lower than the
engine (in a bucket on the ground). Instead of needing a pump or
sucking on the hose to get a siphon started, I was wondering if I might
be able to apply a VERY SMALL amount of air pressure to the crankcase
to get it started. I'd do this probably through the PCV fitting. When
I say VERY SMALL, I mean like 2 or 3 psi. Just enough to get the flow
started. I would increase the pressure in very small doses if 2 or 3
was too little. A dumbass would apply 40 psi and blow out a seal or
gasket. I may be dumb but not that dumb. Can anybody tell me if this
will work or if there are any problems with it?

Chris

I just did mine for the first time last week. I used a little cheapo
pump that you hook to a drill. I think it cost $5 or so from Harbor
Freight, but I just had it laying around in the garage. I had to add
the hose and fittings which are just standard garden hose parts. Total
outlay (including the original cost of the pump) might have reached
$10 to $12. It only took a few minutes to pump out. I would simply buy
a pump and do it as designed.

The Other Dave Hall

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mercruiser Bravo winterizing - outdrive lube change.	Rich	General	2	October 18th 04 10:28 PM
5.7L Mercruiser Carb change?	matthew siroky	General	2	September 3rd 03 01:41 PM
? Mercruiser oil vs synethic oil	frank news	General	0	August 14th 03 11:42 PM

Menu

About Us