oooo no

krause knows all these presidents??? lol,,oooo no,,, ouch ,,

he knows Jimmy Hoffa,, I mean this fool krause must have finally spun his
top.

O course his puppets are standing at attention right about now,,

krause,,, I didn't know that you knew all these presidents,,, lol,,, I mean
what do they think when they are out on a social event with you,, and you
are on government assistance. lol,, ooo my ,,, now do they know you from you
holding a picket sign in the crowds? Like you do holding two union cards and
closing business? krause,, you are just about over the deep end now
krause,,, lol,,,,






"K. Smith" wrote in message
...
John H wrote:
On Fri, 29 Apr 2005 19:26:36 -0400, "r_d"

wrote:


Hi all,



I have a boat (obviously) with a 1986 OMC stern drive with a Chevy 350.
The boat has not been used in 6 years and I would like to get it running.



The prop is seized (I think it is stuck to the drive by corrosion of the
alum in the space between the prop and alum drive), so the first thing I
plan to do is pull the prop and clean everything. I also plan to change
the drive oil and if it is clean (which it should be as it was change
before storage) I will go on with getting the engine running. Figuring
if the drive is bad no need to go further.



I plan to replace the drive water pump and do a full tune up (plugs,
wires, rotor, cap, points and condenser, "fan" belt, rubber fuel lines,
fuel filters, carb rebuilt and oil and filter). The exhaust manifolds
were replaced just before it was winterized and left to sit so all this
time it has been sitting with marvel mystery oil in the cylinders and
antifreeze in the block and manifolds. The engine does spin freely and
builds oil pressure but I did not try to start it yet. Can anybody think
of anything else that would degrade in that time frame? And does anybody
know of an online site for parts and tools (like a prop puller)?



Thanks for your help,

mark


If it has a Mercruiser engine (gm) you can try here for parts, but you'll
need a
serial number.
http://www.mercurypartsexpress.com/P...99070235055275

Good luck.


You say it was "winterised" i.e. it had fogging oil or similar sprayed
into intake at idle till it stopped?? then the plugs were removed & a
goodly dose of oil (you say marvel whatever) put in??. Assuming it hasn't
suffered freeze damage then it should be OK. make sure you give it a good
spin without the plugs in to avoid an hydraulic lock from the excess
storage oil on startup.

After the first few runs, outings so the valves rings etc have had time to
settle in then do a compression check etc & if all is well then all is
well:-)

As you allude the real risks are in the drive, but fresh oil, new pump etc
& give it a go.

Good luck.

K

& the Krause lie for the day is an oldie but a goodie:-)

So this lying idiot sees himself as circulating in the upper circles,
honestly this lying idiot thinks this is believable, which is more proof
of his total stupidity:-)

As far as your other complaints, well, almost every president in
my memory, and I *remember* Truman, Eisenhower (who cheated on his wife),
Kennedy, Johnson, Nixon, Ford, Carter, Reagan and Bush, lied and
participated in deceit to one degree or another, and on issues far more
important than who was giving them blow jobs.

Good lord. I met *every* president in the damned group except
Bush, and I worked once for his father.