Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #11   Report Post  
 
Posts: n/a
Default

90 amp fuse is 88-79023A90 seems to be the issue. Gonna get one and
replace the old one. Keeping my fingers crossed. ;-)

  #12   Report Post  
N.L. Eckert
 
Posts: n/a
Default

I got the boat ready Saturday to start her up for the first time. Been
charging the battery during the winter months. Hooked it up. Raised the
lower unit so I can move her to the driveway. Lowered it back down.
Checked all the fluids. Everything looked good. Put the muffs on and
turned on the water. Turned the Key and nothing. Nothing at all worked.
Radio doesn't come on and the horn doesn't even work. Battery is fully
charged, fuses are fine, kill switch is not engaged. I had a friend of
mine who was working on it so I am not sure which cables he jumped on
the starter/solenoid. When I turn the key there is no power anywhere in
the boat and it doesn't click the starter either. He did a jump at the
starter and got it to turn the motor a little. Then he jumped another
wire and there was power back in the entire boat. Where is my problem?
--------------------
1999 SeaRay 180 Bowrider,
3.0L Merc 135hp I/O
==================================
There should be a cluster of about 6 wires on top of the engine. This
is for breaking away all the connections at one point for removing the
engine from its mounts. Over the winter these connections can corrode
and lose contact. Take some very fine crocus cloth sand paper and clean
up the male connections. Then, roll up some of the paper, making it
into a small tube and clean up into the female connections.
Plug it all back to gether and see if you have power.

Good luck, Norm

  #13   Report Post  
 
Posts: n/a
Default

It was the fuse! We have power and the boating season can begin! Thanks
guys.

  #14   Report Post  
William G. Andersen
 
Posts: n/a
Default

I'm surprised that no one mentioned checking the fuses. Besides the 50 or 55
amp one back in the engine compartment, there should be about 10 on the back
of the instrument panel, near the switches. (My 1998 model 1950CL has a
yellow fuse for the ignition.) You probably won't be able to see the fuse
block while you're reaching for the fuses, so it takes a few minutes to get
your arm up in there and check them one at a time.


wrote in message
oups.com...
Guaranteed I will be doing this.



Reply
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is Off
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
mercruiser backfiring, destroying distributor caps dave General 12 July 17th 04 08:44 AM
Math Problem SkitchNYC ASA 102 March 5th 04 12:43 AM
Fishfinder??? Bobsprit ASA 31 January 26th 04 09:06 PM
Mercruiser tilt problem, help Jodon2 General 3 September 21st 03 03:37 AM
back with a problem now Nancy General 14 August 2nd 03 04:43 AM


All times are GMT +1. The time now is 05:46 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 BoatBanter.com.
The comments are property of their posters.
 

About Us

"It's about Boats"

 

Copyright © 2017