You need a Red Dot heater.

On 10 Nov 2004 17:28:47 GMT, (Gould 0738) wrote:

You need a Red Dot heater.

Ah - very informative.

Thanks.

Later,

Tom

Gould 0738 wrote:
You need a Red Dot heater.

I am getting a real chuckle out of some of Chuck's recent posts. For a
guy with superb writing skills, he is becoming a man of few words, yet
gets the point across.

"consider cork"

and this one ...

Eisboch

On Wed, 10 Nov 2004 13:35:29 -0500, Eisboch
wrote:

Gould 0738 wrote:
You need a Red Dot heater.

I am getting a real chuckle out of some of Chuck's recent posts. For a
guy with superb writing skills, he is becoming a man of few words, yet
gets the point across.

"consider cork"

and this one ..

At least he could have attached a URL.

Efficient indeed. :)

Take care.

Tom

"The beatings will stop when morale improves."
E. Teach, 1717

My thought was to pull heat off the engine much like the radiator
system in a car.

Check out http://www.heatercraft.com/

I have one of their "1H" models in my ski boat. Works great! Even in a
totally open ski boat you can get enough heat out of the vents to keep the
driver warm and toasty. The vents pull out and extend on hoses and you will
often see the observers covered in a blanket with the heater vent tucked up
underneath keeping them warm as well. I am sure that if you had any kind of
enclosure you could get enough heat to keep the cabin reasonably warm.

You have to be running, of course.

If you want heat while the engine is off then I would recommend a small
portable propane unit. I have a propane heater similar to this one:
http://www.mrheater.com/productdetail.asp?id=675 (the double head) that I
used to heat the flybridge of my 36' Carver. I never used both burners at
one time on the boat, and often I had trouble getting turned down low enough
so that it didn't roast us out. If you use something like this take extra
precautions that it is tied down and can't possibly tip over.

Rod McInnis

"rmcinnis" wrote:

My thought was to pull heat off the engine much like the radiator
system in a car.

Check out http://www.heatercraft.com/

I have one of their "1H" models in my ski boat. Works great! Even in a
totally open ski boat you can get enough heat out of the vents to keep the
driver warm and toasty. The vents pull out and extend on hoses and you
will often see the observers covered in a blanket with the heater vent
tucked up underneath keeping them warm as well. I am sure that if you had
any kind of enclosure you could get enough heat to keep the cabin
reasonably warm.

Rod McInnis

Rod,

That little "1H" unit would work nicely on my boat too.
Approx how much did it cost?

Gary

On Wed, 10 Nov 2004 12:03:13 -0800, "rmcinnis"
wrote:


My thought was to pull heat off the engine much like the radiator
system in a car.

Check out http://www.heatercraft.com/

I have one of their "1H" models in my ski boat. Works great! Even in a
totally open ski boat you can get enough heat out of the vents to keep the
driver warm and toasty. The vents pull out and extend on hoses and you will
often see the observers covered in a blanket with the heater vent tucked up
underneath keeping them warm as well. I am sure that if you had any kind of
enclosure you could get enough heat to keep the cabin reasonably warm.

This is a curious and somewhat confusing image. An open ski boat,
towing a skier and the driver/observer huddling under blankets with
hoses from the heating duct to warm up.

And I thought horse owners were nuts.

Mrs. E excepted of course. ;)

You have to be running, of course.

Of course. :)

If you want heat while the engine is off then I would recommend a small
portable propane unit. I have a propane heater similar to this one:
http://www.mrheater.com/productdetail.asp?id=675 (the double head) that I
used to heat the flybridge of my 36' Carver. I never used both burners at
one time on the boat, and often I had trouble getting turned down low enough
so that it didn't roast us out. If you use something like this take extra
precautions that it is tied down and can't possibly tip over.

Part of the exercise is not to vent an enclosed space other than
ambient drafts.

However, I appreciate the info and I've got it in my to check out
later bookmark.

Thanks.

By the by, just kidding about the skiing.

Not!! :)

Later,

Tom

On Wed, 10 Nov 2004 12:26:51 GMT, Short Wave Sportfishing
wrote:

The more I get into designing the new interior of this '68 Chris Craft
Corsair I want to turn into a winter boat, the more I get to wondering
about different things. One of which was brought home this morning as
I took the dogs out for exercise.

Having arthritis, cold isn't my friend. Adding to that, I don't enjoy
the cold all that much - never have. I tolerate it, but I don't like
it. Therefore, it is paramount in a winter boat to have....

HEAT.

My thought was to pull heat off the engine much like the radiator
system in a car. The way the design is developing, there will be an
interior cabin of a sort or at least a place where one could get out
of the wind, rain, etc. Think of a Parker/Steiger type pilot house
without the adjoining cuddy space. This is where I would put the
heating unit.

I'm just not sure this is a valid way of heating this small space.

Any thoughts?

Later,

Tom
-----------
"Angling may be said to be so
like the mathematics that it
can never be fully learnt..."

Izaak Walton "The Compleat Angler", 1653

I went with propane for my cabin cruiser. 3000 BTU keeps the cabin t-shirt
warm in 40F or lower temps.

I couldn't find a marine unit so I installed a RV catalytic like the one
shown in the link that follows.

My wife and I camp on our boat spending an entire weekend day and night. So
we might have different needs since we are anchored most of the time.
anyway, here is a link to one similar to mine.

http://www.campingworld.com/browse/s...m?skunum=19332





Regards
John S

I would rather be boating!

A very practical problem is windshield fogging. This happened on my boat one
cool evening this Fall, and after I realized it wasn't getting foggy
outside, I had my daughter up on the foredeck wiping the windows constantly
while I sponged them off inside - just so we could see. The amount of sudden
condensation was formidable. (Trojan 26.)

Is general pilothouse heating adequate for this? I suspect not. Anyone heat
their windshields, the way the "defrost" setting works in an automobile?

====

Charles T. Low
www.boatdocking.com

====

"Short Wave Sportfishing" wrote in message
...
The more I get into designing the new interior of this '68 Chris Craft
Corsair I want to turn into a winter boat, the more I get to wondering
about different things. One of which was brought home this morning as
I took the dogs out for exercise.

Having arthritis, cold isn't my friend. Adding to that, I don't enjoy
the cold all that much - never have. I tolerate it, but I don't like
it. Therefore, it is paramount in a winter boat to have....

HEAT.

My thought was to pull heat off the engine much like the radiator
system in a car. The way the design is developing, there will be an
interior cabin of a sort or at least a place where one could get out
of the wind, rain, etc. Think of a Parker/Steiger type pilot house
without the adjoining cuddy space. This is where I would put the
heating unit.

I'm just not sure this is a valid way of heating this small space.

Any thoughts?

Later,

Tom
-----------
"Angling may be said to be so
like the mathematics that it
can never be fully learnt..."

Izaak Walton "The Compleat Angler", 1653

Charles T. Low wrote:
A very practical problem is windshield fogging. This happened on my boat one
cool evening this Fall, and after I realized it wasn't getting foggy
outside, I had my daughter up on the foredeck wiping the windows constantly
while I sponged them off inside - just so we could see. The amount of sudden
condensation was formidable. (Trojan 26.)

Is general pilothouse heating adequate for this? I suspect not. Anyone heat
their windshields, the way the "defrost" setting works in an automobile?

====

Charles T. Low
www.boatdocking.com

====


Howdy, Charles,

I've never seen a window defogger setup on a boat. Automotive
defogger/defroster systems use heat plus run the A/C unit to remove the
moisture that is condensing. I recall having cars without air
conditioning and the heat only defogger was not as effective.

An exotic solution would be having your windows coated with transparent
but conductive coating such as Indium Tin Oxide and then pass current
through the coating to heat the windshield. Military and commercial
airplanes use this technique on many of the cockpit display panels and
windshields. Also, I wonder if there is an after market automotive thin
wire defroster that could be applied to the windows, similar to the
electric heater wires in the rear windows of most cars.

Eisboch