About Us

On 23 Aug 2004 20:32:19 -0700, (Matt Lang) wrote:

"Doug Kanter" wrote in message ...
We interrupt the political programming to bring you a boat question.

Thats ok this time, but lets not make it habbit to fill this group
with boat posts, its already hard to focus on the political discussion
as all these boat posts pop up (why?)

hahahaha

My 14' Lund aluminum yacht has been exhibiting some odd behavior at the
transom, and the last foot of the sides. Lots of spray. I've seen transom
spray when the motor's been dragging a large clump of weeds, and spray from
the sides when the boat's obviously (but rarely) overloaded. Now, I'm seeing
a combination of both. Absolutely NOTHING about the boat has been changed,
at least not by me. No accessories added or moved, and the motor hasn't
banged against any obstructions, and its angle has not been adjusted in
years. There is no bilge, so I'm positive it's not a matter of collected
water.

I have a 14 ft inflatable and been fighting transom spray. Especially
in a light boat I found the weight affects the distance the prop is in
the water and changes spray.... This doesnt seem to be the case with
your boat...

Another source for spray can be damage in the edge of the transom
where it exits the water.

Thats about as much as I can think of ... hope it helps.

Another potential problem maybe the "skegs" - there should be two
running the length of the hull port and starboard (I can't think of
any other word than skeg for these runner type thingies). I had that
happen on a 16 foot Lund years ago.

Perhaps you have changed a little? :)

Good luck.

Later,

Tom

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mercruiser coupler replacement / transom issues	Rich	General	4	August 10th 04 10:07 PM
transom repair	K. Smith	General	0	August 7th 04 02:01 AM
transom support	Mike Kasiorek	General	7	May 10th 04 10:23 PM
Transom cutout size for 130 hp	Sylvester Sullivan	General	0	April 4th 04 06:01 AM
Transom Height - Dumb Question Alert	Michael Gagliardi	General	0	August 28th 03 07:31 PM

Menu

About Us