BoatBanter.com

BoatBanter.com (https://www.boatbanter.com/)
-   General (https://www.boatbanter.com/general/)
-   -   Evenrude only runs wide open (https://www.boatbanter.com/general/21552-evenrude-only-runs-wide-open.html)

calhoun August 15th 04 10:23 PM

Evenrude only runs wide open
 
HI

1986 4HP, runs great wide open but will not run slow unless the choke is
partially pulled. This has been a problem that has slowly developed over the
season. I used to be able to use the mixture screw and get it to run at
troll speed. That no longer can be adjusted enough. Any ideas on the cause?

thanks

Paul



John S August 16th 04 12:27 AM

On Sun, 15 Aug 2004 21:23:22 GMT, "calhoun"
wrote:

HI

1986 4HP, runs great wide open but will not run slow unless the choke is
partially pulled. This has been a problem that has slowly developed over the
season. I used to be able to use the mixture screw and get it to run at
troll speed. That no longer can be adjusted enough. Any ideas on the cause?

thanks

Paul


Gumming up of the carb idle jets? Just a thought. Have you tried a
lot of gumout?

Had a V8 catch me like that once.



Regards
John S

Tony Thomas August 16th 04 01:44 AM

Rebuild the carb.

--
Tony
my boats at http://t.thomas.home.mchsi.com

"calhoun" wrote in message
...
HI

1986 4HP, runs great wide open but will not run slow unless the choke is
partially pulled. This has been a problem that has slowly developed over

the
season. I used to be able to use the mixture screw and get it to run at
troll speed. That no longer can be adjusted enough. Any ideas on the

cause?

thanks

Paul





Mikkilla August 16th 04 01:52 PM



HI

1986 4HP, runs great wide open but will not run slow unless the choke is
partially pulled. This has been a problem that has slowly developed over the
season. I used to be able to use the mixture screw and get it to run at
troll speed. That no longer can be adjusted enough. Any ideas on the cause?

thanks

Paul



Your Idle/slow spped circut in the carb is either gummed up OR your mixture
needle is worn down and is now letting to much air by. pull the needle out look
at the tip.. does it have a grove in it.. does it even have a sharp point
anymore? These carbs are really easy to pull and clean out don't be afraid of
it really isn't much to them. But if you have the Black Thumb of death on
fixing mechanical things. i leave it be and have a boat mechanic fix it.. and
if it takes one more then a hour to fix. they are a idiot.



All times are GMT +1. The time now is 02:17 AM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 BoatBanter.com