John H Wrote in message:
On Thu, 4 Jan 2018 13:16:34 -0500, "Mr. Luddite" wrote:

On 1/4/2018 1:07 PM, John H wrote:
On Thu, 4 Jan 2018 12:42:29 -0500, "Mr. Luddite" wrote:

On 1/4/2018 12:20 PM, wrote:
On Thu, 04 Jan 2018 08:54:03 -0500, John H
wrote:

On Wed, 3 Jan 2018 17:19:35 -0500, "Mr. Luddite" wrote:

On 1/3/2018 2:28 PM, Its Me wrote:
Light flurries now, the predictions range from a dusting to 1-2 inches. Worse the closer to the coast you get. My BIL at James Island (Charleston) sent a picture earlier of maybe 1/4 inch and still falling. Very unusual for them.

It's out of here in a few hours and headed up the coast. Good luck!



Damn. I was hoping it would dump a foot in Mt. Pleasant, just to shut
my son up.

Last I heard it is supposed to "explode" as it comes up the coast,
becoming essentially a winter hurricane.

"Bombogenesis" is the technical term, and the popular "bomb cyclone" is a shortened version of it,
according to our weather folks.

They do seem to just make up names for things these days. I think the
classic was "Super Storm Sandy" to talk about something that was not
even a hurricane, it was just "super" for people who were not used to
tropical weather.
It is far from unprecedented tho. There was a real Cat 3 there in the
30s.
I have certainly seen that weather pattern in DC tho and this is not
even the worst case. The snow would actually be more of a problem if
the "eye" of that low was farther west so your wind was drawing wet
gulf stream air up into the cold front north of you. That is what
gives DC over a foot of snow a day and if it stalls, you
"Knickerbocker" snow.


Up here a Cat 1 hurricane in the summer might be preferable over what is
going on right now. When you look at this storm on radar it is
developing a very defined rotation as it is winding up and getting
bigger. Snowfall rate here is 2-3 inches/hr and the temp is dropping
like a rock since this morning. Pretty much a white-out out there.

Major flooding in Justin's former town with 4 disabled cars with people
trapped inside, one a woman with 2 kids. Water is over the wheel wells.
Fire and National Guard are responding.

My old stomping grounds in Scituate is really getting clobbered ...
worst in over 30 years despite improvements in sea walls, etc. A TV
reporter nut was standing on the porch of a house about 30 feet from the
seawall and he was getting soaked with spray, along with dodging sea ice
that is being thrown up onto the roofs of houses.

So far we haven't had any power glitches here but I fully expect we'll
lose it in the next hour or so. Wind where I am is gusting 55-60 mph.

Best of luck in all that. I think I'd be getting out the extension cords and prioritizing my
electricity requirements!


Did that yesterday ... that's why I was firing up the Honda to test.

I have a new plan. If power goes out I am going to shut off the main
breaker and then backfeed the generator output through a 15 amp outlet
that's in the shed. It's on the same branch of the split 240v house
supply as the furnace and a couple of rooms. All my lighting is LED, so
that's a tiny load. The generator will run those plus the furnace
system with no problem and I don't need to have extension cords running
anywhere.


Well, you know more about electricity than I do. That's something I'd never try. Came across this
while looking for info. Don't know if it'll help or you already have it down.

http://www.tcscooters.com/backfeed.htm

I like steps 1-3:

If you are going to backfeed your home, you must be very carefully and follow the directions below.
If you fail to follow them you can kill a line worker, kill yourself or blow up your generator.
Again I'll say, get a licensed electrician.

Step One, the most important step of all is to turn off the main breakers.
Step two, turn off the main breakers.
Step three, turn off the main breakers. Do you get the idea?
Step four, remember to plug the generator end in last. If the generator is running and you are using
two male ends the house end plug is live!


A friend of mine bought a kit to do it safely; simple but genius.
Install a 220 breaker right below your 220 mains. They provide a
simple slider that won't let you switch on both breaker sets at
the same time. The newly installed breaker set feeds a new panel
box with a 50 A jack like your RV plugs into. Make up a cord to
connect your genset and you're done. Turn off all load breakers.
Connect the cord at both ends and start the genset then you can
switch the power.
--
x


----Android NewsGroup Reader----
http://usenet.sinaapp.com/