Home |
Search |
Today's Posts |
#1
![]() |
|||
|
|||
![]()
I have an 88 100 horse Merc outboard, oil injection. It seems to be
injecting oil at the rate of 1 litre every 1 1/2 hrs of operation. Manual says the 4 litres should last 18 hours at WOT. It is not leaking out and the motor is not emitting any visible smoke. It seems to run normally. The motor is a recent purchase and I don't really know if this is a sudden development or not. Possibly related: Temp gauge only lifts off of 60F a bit when I boat in warmer water. Usually it doesn't move at all. This is either a bad temp sender or bad thermostat which causes motor to never really get warmed up properly. Would a stuck open thermostat cause excessive oil consumption? Is there an adjustment that can be made to the oil injection pump? Any advice is appreciated. Vacation is coming and I don't want to tow the boat 100 miles to the mechanic if I can avoid it. -- Denis Roy D. Roy Woodcraft www.ideasinwood.com |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Merc 1250 Impeller/waterspray - Clams? :) | General | |||
Replacing merc thermostat housing | General | |||
old merc compression | General | |||
Merc 1250 runs :) ... boat slow :( | General | |||
Which engine for new pontoon, 60 hp merc BigFoot or 90 hp merc | General |