On 5/12/2013 5:27 PM, Tim wrote:
On May 12, 4:09 pm, Wayne B wrote:
On Sun, 12 May 2013 12:52:22 -0700 (PDT), Tim
wrote:

though some here have disputed the practice, I still say that
solderless crimp connections always work best with a drop of solder on/
in them.

=======

The experts say no because the solder creates a "hard spot" which can
work harden and break after repeated vibration, same as using solid
copper wire instead of stranded. There is nothing wrong with a good
crimped connection if it is made properly and kept dry. One of the
secrets to keeping it dry are to always install them with the wire
pointed downward, and/or have a drip loop within an inch or two of the
connector.

http://captnpauley.typepad.com/.a/6a0111685112b3970c0105371a237d970b-...

Oh, I do understand that, but i understand what I do. And what I do
seems to work well for me. then again, What i do on wiring, isn't
really a strategic process, but in some cases, the ' keeping dry'
is.
I've had wire crimped well into a connector and with a matter of
simple humidity, still corrode over rime making the connection
useless.

I do understand the 'hard spot' theory, but I also understand
anchoring the wire is important as well.

?;^ D

The primary consideration is a strong mechanical connection (crimp).
Soldering has limited value except in high current situations. The best
corrosion prevention starts with tinned wire. followed by waterproofing
the connection.