BoatBanter.com

BoatBanter.com (https://www.boatbanter.com/)
-   General (https://www.boatbanter.com/general/)
-   -   Swim Platform Project (https://www.boatbanter.com/general/120533-swim-platform-project.html)

Crotchedy Harry November 22nd 10 02:50 PM

Swim Platform Project
 
In article , payer33859
@mypacks.net says...

On 11/21/10 3:13 PM, YukonBound wrote:


"Wayne.B" wrote in message
...
One of the joys of owning a boat with a lot of exterior wood trim is
the maintenance work. With 29 years in the sun and salt air, the
teak in our swim platorm was getting thin, brittle and badly worn.
After several years of patchwork repairs it finally seemed time to do
the job right and rebuild the entire thing. No problem. In
exchange of about a boat buck for freshly milled teak strips and a few
new tools, the job is well underway.

Here's a picture of a new strip being sprung into place with clamps
and spacers:

http://img190.imageshack.us/img190/921/swimplatformconstructio.jpg

Notice the reflections in that fine looking transom. :-)

The strips are 15 feet long, 1 1/2 iches wide and about 7/8ths thick,
approximately 25 board feet before milling.

Any suggestions for how to finish the teak when it is finished?


I just used teak oil on the thwart of my daysailer.



You shouldn't use esoteric boating words (thwart) in this newsgroup;
some of the spoofers won't get it.


Nice insulting! That should help with the group harmony.

Crotchedy Harry November 22nd 10 02:51 PM

Swim Platform Project
 
In article ,
says...

"HarryK" wrote in message
m...
On 11/21/10 3:13 PM, YukonBound wrote:


"Wayne.B" wrote in message
...
One of the joys of owning a boat with a lot of exterior wood trim is
the maintenance work. With 29 years in the sun and salt air, the
teak in our swim platorm was getting thin, brittle and badly worn.
After several years of patchwork repairs it finally seemed time to do
the job right and rebuild the entire thing. No problem. In
exchange of about a boat buck for freshly milled teak strips and a few
new tools, the job is well underway.

Here's a picture of a new strip being sprung into place with clamps
and spacers:

http://img190.imageshack.us/img190/921/swimplatformconstructio.jpg

Notice the reflections in that fine looking transom. :-)

The strips are 15 feet long, 1 1/2 iches wide and about 7/8ths thick,
approximately 25 board feet before milling.

Any suggestions for how to finish the teak when it is finished?

I just used teak oil on the thwart of my daysailer.



You shouldn't use esoteric boating words (thwart) in this newsgroup; some
of the spoofers won't get it.


~~ Snerk ~~ I see what you mean!


Insulting should help with the group harmony, eh?

Crotchedy Harry November 22nd 10 02:52 PM

Swim Platform Project
 
In article , says...

On 11/22/10 9:21 AM, I am Tosk wrote:
In ,
says...

On 11/22/10 8:44 AM, I am Tosk wrote:

"The No Spoof wrote in message ...
On 11/21/10 3:51 PM, YukonBound wrote:


The place is cleaned up a lot, what the **** do you want. Donnie, Jps,
and Bob won't ever stop but at the same time have absolutely nothing to
add either so just plonk 'em and stop making us read the trolls..


You are responding to someone whose only interest here is in stirring up
crap. He, "Ziggy," and a couple of others, one of whom is still ID
Spoofing, have no other reason for being here.


And you respond to Donnie who is only here to stir up crap.. Most have
come a long way here, some have not. If you want us to ignore "them" you
should ignore "them" too...




Don is a long-time boater who currently has and uses his boat. There's
no evidence the ID spoofers you enable are boaters.


There's no "evidence" that you or Don own a boat either.

Ziggy[_3_] November 22nd 10 03:19 PM

Swim Platform Project
 
On 11/22/2010 9:01 AM, HarryK wrote:
On 11/22/10 8:44 AM, I am Tosk wrote:

"The No Spoof wrote in message
...
On 11/21/10 3:51 PM, YukonBound wrote:



The place is cleaned up a lot, what the **** do you want. Donnie, Jps,
and Bob won't ever stop but at the same time have absolutely nothing to
add either so just plonk 'em and stop making us read the trolls..


You are responding to someone whose only interest here is in stirring
up crap. He, "Ziggy," and a couple of others, one of whom is still ID
Spoofing, have no other reason for being here.

Oh cmon dip****. I gave a valid response to Wayne's request whereas you
don't have a clue about boat upkeep. So why did you bother to respond?

Ziggy[_3_] November 22nd 10 03:24 PM

Swim Platform Project
 
On 11/22/2010 9:52 AM, Crotchedy Harry wrote:
In , says...
On 11/22/10 9:21 AM, I am Tosk wrote:
In ,
says...
On 11/22/10 8:44 AM, I am Tosk wrote:

"The No Spoof wrote in message ...
On 11/21/10 3:51 PM, YukonBound wrote:

The place is cleaned up a lot, what the **** do you want. Donnie, Jps,
and Bob won't ever stop but at the same time have absolutely nothing to
add either so just plonk 'em and stop making us read the trolls..

You are responding to someone whose only interest here is in stirring up
crap. He, "Ziggy," and a couple of others, one of whom is still ID
Spoofing, have no other reason for being here.
And you respond to Donnie who is only here to stir up crap.. Most have
come a long way here, some have not. If you want us to ignore "them" you
should ignore "them" too...



Don is a long-time boater who currently has and uses his boat. There's
no evidence the ID spoofers you enable are boaters.

There's no "evidence" that you or Don own a boat either.

We have seen pictures of Don's rowboat with the aux motor. Harry has
posted about several of his ficticious yachts. You can tell by their
postings that they know little about boats.

HarryK[_4_] November 22nd 10 04:26 PM

Swim Platform Project
 
On 11/22/10 11:11 AM, WaIIy wrote:
On Mon, 22 Nov 2010 08:44:27 -0500, wrote:


They never stopped. It's obvious that being well behaved is beyond their capabilities. Too bad. Were it not for those two, we could have cleaned up rec.boats.


Interesting, I wondered if it was the same Krause as in rec.boats.
Apparently he is faking it with the politeness.

I recall an election bet for $100.00 one year. He denied the bet and
refused to pay up and send a check to Make a Wish.



I remember you, Wally. You were the winner of a contest no one wanted to
win. You don't know Ziggy. He posts here using the ID's of other
posters. We call it ID spoofing. Cute, eh?

I am Tosk November 22nd 10 04:28 PM

Swim Platform Project
 
In article , WaIIy@
(nft).invalid says...

On Mon, 22 Nov 2010 08:44:27 -0500, Ziggy® wrote:

"The No Spoof Zone" wrote in message ...
On 11/21/10 3:51 PM, YukonBound wrote:


"HarryK" wrote in message
m...
On 11/21/10 3:13 PM, YukonBound wrote:


"Wayne.B" wrote in message
...
One of the joys of owning a boat with a lot of exterior wood trim is
the maintenance work. With 29 years in the sun and salt air, the
teak in our swim platorm was getting thin, brittle and badly worn.
After several years of patchwork repairs it finally seemed time to do
the job right and rebuild the entire thing. No problem. In
exchange of about a boat buck for freshly milled teak strips and a few
new tools, the job is well underway.

Here's a picture of a new strip being sprung into place with clamps
and spacers:

http://img190.imageshack.us/img190/921/swimplatformconstructio.jpg

Notice the reflections in that fine looking transom. :-)

The strips are 15 feet long, 1 1/2 iches wide and about 7/8ths thick,
approximately 25 board feet before milling.

Any suggestions for how to finish the teak when it is finished?

I just used teak oil on the thwart of my daysailer.


You shouldn't use esoteric boating words (thwart) in this newsgroup;
some of the spoofers won't get it.

~~ Snerk ~~ I see what you mean!

Now Don, do you really think anyone would think you and Harry are not up
to your old tricks of insulting?

Snerk

--
Spoofers can go to Hell in a handbasket



They never stopped. It's obvious that being well behaved is beyond their capabilities. Too bad. Were it not for those two, we could have cleaned up rec.boats.


Interesting, I wondered if it was the same Krause as in rec.boats.
Apparently he is faking it with the politeness.

I recall an election bet for $100.00 one year. He denied the bet and
refused to pay up and send a check to Make a Wish.


Water over the bridge and I am sure there is another side to the story
nobody here wants to hear... Rec.Boats and most of us here are trying to
make a comeback, so join in, or continue lurking. The question you
gotta' ask yourself is why did you come to rec.boats in the first place,
boating or trolling?

--
Rowdy Mouse Racing - Pain is temporary, Glory is forever!

HarryK[_3_] November 22nd 10 04:34 PM

Swim Platform Project
 
On 11/22/10 11:28 AM, I am Tosk wrote:
In , WaIIy@
(nft).invalid says...

Interesting, I wondered if it was the same Krause as in rec.boats.
Apparently he is faking it with the politeness.

I recall an election bet for $100.00 one year. He denied the bet and
refused to pay up and send a check to Make a Wish.


Water over the bridge and I am sure there is another side to the story
nobody here wants to hear... Rec.Boats and most of us here are trying to
make a comeback, so join in, or continue lurking. The question you
gotta' ask yourself is why did you come to rec.boats in the first place,
boating or trolling?


Your best response ever. Really.

YukonBound November 22nd 10 04:52 PM

Swim Platform Project
 


"Ziggy" wrote in message
...
Oh cmon dip****. I gave a valid response to Wayne's request whereas you
don't have a clue about boat upkeep. So why did you bother to respond?



Name calling is great for the group peace & harmony.................


Crotchedy Harry November 22nd 10 04:55 PM

Swim Platform Project
 
In article , payer33859
@mypacks.net says...

On 11/22/10 11:11 AM, WaIIy wrote:
On Mon, 22 Nov 2010 08:44:27 -0500, wrote:


They never stopped. It's obvious that being well behaved is beyond their capabilities. Too bad. Were it not for those two, we could have cleaned up rec.boats.


Interesting, I wondered if it was the same Krause as in rec.boats.
Apparently he is faking it with the politeness.

I recall an election bet for $100.00 one year. He denied the bet and
refused to pay up and send a check to Make a Wish.



I remember you, Wally. You were the winner of a contest no one wanted to
win. You don't know Ziggy. He posts here using the ID's of other
posters. We call it ID spoofing. Cute, eh?


Nice insulting. That should help the group harmony.


All times are GMT +1. The time now is 04:34 PM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004 - 2014 BoatBanter.com