Home |
Search |
Today's Posts |
#20
![]()
posted to rec.boats.electronics
|
|||
|
|||
![]()
On Fri, 1 Sep 2006 09:45:56 -0700, "Paul" wrote:
Thank you for this information. I don't know what equipment was used on the ship I encountered, but this is a completely plausible explanation for what I was seeing. Perhaps I will try to locate the ship owner and send them a message -- it couldn't hurt! If they are using the Furuno GP80 or GP90 it's quite likely. I found about 30% of vessels around here use those GPS models and about 1/3 of them were "cheating" by putting their paper chart offsets into their GPS, thereby causing the problem. What port were you in when you discovered this problem? It was Labuan, a small island off the coast of Borneo. Dave |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
circuit for running two bulbs from one run of 2 conductor wire? | Boat Building | |||
How to Position an Auxiliary Motor on the Transom of a 18-ft Power Boat? | Cruising | |||
B&G Pilot rudder position calibration | Electronics | |||
Not one person | ASA | |||
RDF for newbies and NN of KN | ASA |