Problem with 276C using a Goto in an active Route

Pascal

Posts: n/a

Hi There,

Even if nobody replied this, I will make this update. The problem
hapens only if you do a Enroute Goto, pass the goto waypoint, and after
you power off/power on the unit. After the power on, instead of
detrmine the correct route waypointt to go, it "remembers" the last
Goto, and them, navigate to it, wich is WRONG.

Regards
Pascal

Reply With Quote

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
Smilies are On [IMG] code is Off HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem Solved: Map 276C AP NMEA Interface	Pascal	Electronics	3	May 31st 05 04:08 PM
Problem Solved: Map 276C AP NMEA Interface	Pascal	Cruising	0	May 30th 05 01:23 AM
GpsMap 276C NMEA Interface Problem	Pascal Goncalves	Electronics	3	March 2nd 05 01:02 PM
Loss pf Power problem with Yanmar Engine	Jerry Poore	Cruising	3	June 26th 04 05:02 PM
back with a problem now	Nancy	General	14	August 2nd 03 04:43 AM

All times are GMT +1. The time now is 03:35 AM.

Menu

About Us