Menu

Westerbeke 7.0 BCG genset woes

Search this Thread

Prev

Previous Post

Next Post

Next

#2

Report Post

Bruce in Alaska

Posts: n/a

Default

In article ,
(C. Sadler) wrote:

If I release either, the engine dies, like you hit the stop switch. I
have measured a good 12v on the fuel cutoff solenoid, even when the
switches are released. I have cracked the solenoid from the carb
housing, and have fuel running out, so I "don't" think I have a fuel
pump problem.

Did you bleed the fuel lines, AND the injector lines off all the air
that got pumped into them when you ran out of fuel? Air compresses very
well in the injector pump but will NOT open the injector valves. Sounds
like you still have air in the injector lines. Bleed all the lines
untill you have good fuel going into the top of each injector, and try
starting it again.......

Bruce in alaska
--
add a 2 before @

Reply With Quote

Reply With Quote

Thread Tools	Search this Thread
Show Printable Version	Search this Thread: Advanced Search
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
Smilies are On [IMG] code is Off HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Westerbeke genset - not developing sufficient voltage	C. Sadler	Cruising	4	April 1st 04 05:04 PM
Westerbeke genset - new information	C. Sadler	Electronics	0	March 27th 04 11:08 PM
Westerbeke genset question	C. Sadler	Electronics	4	March 27th 04 02:13 AM
Fischer Panda genset problems	pamula	Cruising	0	February 17th 04 06:46 AM

All times are GMT +1. The time now is 11:35 PM.

About Us

"It's about Boats"

Contact Us BoatBanter Home Privacy Statement

Copyright © 2017