I am going to change boat and I have uninstalled my old TS 430S SSB
that still works fine and I have to reinstall on the new boat.

Discussion on SSB are very frequent, here around, but I have not been
able to find out someone talking of the hard job to clean RFI out of
the on board circuits, when SSB goes on air.
I remember that when I installed the TX I had to put ferrite chokes
and capacitors, for a week, before to obtain a reasonable RFI clean
status.

Now I fear to start again with this job, on the new boat, and I wonder
if someone of you has a reference documentation to suggest, in order
to do it at the best.

Thanks a lot for the attention.

Best regards,
Manlio
IK2RAU


Manlio Laschena
http://Delphi-Jedi.org