| Home |
| Search |
| Today's Posts |
|
#1
|
|||
|
|||
HOW2 install a Martec bronze folding prop [7/8"] onto a S/S shaft [1 1/8"] ?
throw away the Martec now - before it gets you in trouble.
On Fri, 23 Apr 2004 18:03:18 -0400, Courtney Thomas wrote: I already have a Michigan 3 blade on the 1 1/8" shaft, is it possible to adapt the Martec/shaft/Michigan, so that I don't lose use of the Michigan as a backup ? Appreciatively, Courtney |
|
#2
|
|||
|
|||
|
HOW2 install a Martec bronze folding prop [7/8"] onto a S/S shaft [1 1/8"] ?
throw away the Martec now - before it gets you in trouble.
On Fri, 23 Apr 2004 18:03:18 -0400, Courtney Thomas wrote: I already have a Michigan 3 blade on the 1 1/8" shaft, is it possible to adapt the Martec/shaft/Michigan, so that I don't lose use of the Michigan as a backup ? Appreciatively, Courtney |
|
#3
|
|||
|
|||
|
HOW2 install a Martec bronze folding prop [7/8"] onto a S/S shaft [1 1/8"] ?
I already have a Michigan 3 blade on the 1 1/8" shaft, is it possible to
adapt the Martec/shaft/Michigan, so that I don't lose use of the Michigan as a backup ? Appreciatively, Courtney -- s/v Mutiny Rhodes Bounty II lying Oriental, NC WDB5619 |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Prop | General | |||
| Angle of prop shaft - theoretical question. | General | |||
Linear Mode
