Home |
Search |
Today's Posts |
|
#1
|
|||
|
|||
Problem water pump Yanmar 2GM
Rodney wrote:
I may be misunderstanding you here. There is no difficulty telling visually whether a yanmar is raw cooled or fresh. the heat exchanger in the fresh-water-cooled engines is a rectangular tank above and to the right of the cylinder head with a radiator cap in it. It has four hoses, in and out for both raw and fresh water. A raw cooled engine does not have this at all. Yes, it's raw. I always leave the door open to be enlightened when I know I am not an expert. |
#2
|
|||
|
|||
Problem water pump Yanmar 2GM
another problem I have seen on yanmar model 2qm15 is that the Zinc
mounting housing (Salt/raw water cooled) has the hose from the water pump to the zinc housing mounted in a verticle orientation with the hose from water pump to zinc housing coming from underneath the zincs house. When replacing the original hoses I found the zinc had built up a crust inside the hose under the zinc housing to the point where the hose was becoming constricted by the build up, might as well replace your zincs and check for that . "Jeffrey P. Vasquez" wrote in message news:... Yes, it's raw. |
#3
|
|||
|
|||
Problem water pump Yanmar 2GM
another problem I have seen on yanmar model 2qm15 is that the Zinc
mounting housing (Salt/raw water cooled) has the hose from the water pump to the zinc housing mounted in a verticle orientation with the hose from water pump to zinc housing coming from underneath the zincs house. When replacing the original hoses I found the zinc had built up a crust inside the hose under the zinc housing to the point where the hose was becoming constricted by the build up, might as well replace your zincs and check for that . "Jeffrey P. Vasquez" wrote in message news:... Yes, it's raw. |
#4
|
|||
|
|||
Quote:
It runs from cold for as long as I want pumping water from the back but as soon as I shut it down, sail for a bit and then start it up the pump fails. My thinking was this - the cam and inside face of the pump have worn enough from sand/silt that a warm engine creates a pressure differential in the cooling system to prevent a failing/failed pump to pump - but running from cold the cooling system, once pumping, will syphon. However, the notion of the pulley spinning on the spindle (above) also works in my mind, i.e. the pump works and syphons from cold but a hot (and expanded) pulley will not pump although visually all looks good. I'll check the pulley at the weekend but regardless I'm buying a new pump. But, here's the thing. A replacement raw pump - about 40 litres a minute costs £366 but a freshwater pump (exactly the same mounts but a bigger impeller) costs £120 and pumps around 50 litres a minute. I'm sure that the thermostat will regulate the flow through the engine anyway, but has anybody got any experience of increasing the flow in this way? I spoke to Yanmar UK and they told me to fit the raw water pump but had no advice regarding the freshwater pump. |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
yanmar ysb12 water pump | Boat Building | |||
Where to find ramp stories? | General | |||
Fresh Water Tank | Cruising | |||
Hot Water Dispenser | Cruising | |||
Fresh Water System Design Ideas. | Boat Building |