Home |
Search |
Today's Posts |
#18
![]() |
|||
|
|||
![]()
If it is away from the pickup, then it isn't entering into the problem.
If things get stirred up then the polishing system will do its job better. Doug "LaBomba182" wrote in message ... Subject: Fuel transfer/polishing pump From: "Doug Dotson" Yes, but it is better than nothing. At least for that one baffled area. Which may be on the far side of the tank away from the pickup. :-) Capt. Bill |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Problem changing out my fuel pump | General | |||
Engine dies- Putters when trying to plane- engine under under heavy load | General | |||
Can a single 72 gal per hour fuel pump run two 392 cu inch motors? | General | |||
Inboard won't run above 2800 RPM | General | |||
Fuel pump to carbs fuel line replacement | General |