| Home |
| Search |
| Today's Posts |
|
#10
|
|||
|
|||
Fuel transfer/polishing pump
Subject: Fuel transfer/polishing pump
From: "Doug Dotson" The memo from Yanmar (via Mack Boring) didn't make any distinction on type of filter. Just the porosity on the element. Perhaps it was a CYA move to specify anything smaller than 30 uM. If that's the case, then you have to do what they say. At least until the warranty runs out. :-) Capt. Bill |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Problem changing out my fuel pump | General | |||
| Engine dies- Putters when trying to plane- engine under under heavy load | General | |||
| Can a single 72 gal per hour fuel pump run two 392 cu inch motors? | General | |||
| Inboard won't run above 2800 RPM | General | |||
| Fuel pump to carbs fuel line replacement | General | |||
Threaded Mode
