| Home |
| Search |
| Today's Posts |
|
#11
|
|||
|
|||
Fuel transfer/polishing pump
Steven Shelikoff wrote: On Fri, 28 Nov 2003 21:17:43 -0500, Glenn Ashmore wrote: I believe that was for OIL not diesel. Not much difference between diesel and oil. Not much other than viscosity, flow rate, condensate content, contaminants filtered, use of the product being filtered and reason for being filtered in the first place. :-) -- Glenn Ashmore I'm building a 45' cutter in strip/composite. Watch my progress (or lack there of) at: http://www.rutuonline.com Shameless Commercial Division: http://www.spade-anchor-us.com |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Problem changing out my fuel pump | General | |||
| Engine dies- Putters when trying to plane- engine under under heavy load | General | |||
| Can a single 72 gal per hour fuel pump run two 392 cu inch motors? | General | |||
| Inboard won't run above 2800 RPM | General | |||
| Fuel pump to carbs fuel line replacement | General | |||
Threaded Mode
