LinkBack Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #8   Report Post  
DSK
 
Posts: n/a
Default Fuel transfer/polishing pump

Doug Dotson wrote:

This helps alot, thanks! LaBomba suggested that just amking
the primary filter bigger would solve the problem. I was thinking
that this might be a easier solution, but it appears that a separate
polishing system does have advantages over just using a filter
that does not clog up so quickly.


There is a finite amount of filter-clogging gunk in your fuel system at any given time,
the more of it gets in your filter, the less stays in the system (and potentially ends up
in the injector pump & injectors). A filter element that does not clog up as quickly is
either 1- bigger and can thus hold more gunk OR 2- is letting a lot of the gunk pass
thru. QED


My intended strategy is to oly
fill one tank at a time, set the newly filled tank to polishing while
running the engine off of the other tank. Then when the engine
tank gets low, switch the engine to the polished tank, then
fill and polish the other tank. That way I always have clean
fuel ready and waiting (and plenty of it) and I don;t have to rush
to fill again.


Sounds good but it might take a while.



I'm still in a quandry about Raycor style filters vs the paper towel
roll type. Perhaps RichH will chime in on this one since he is an
expert on filtration systems. Does Safeway carry 15 uM paper towels?


At Trawlersfest I had two lengthy discussions with paper towel filter advocates. Their
theory is that the random oriented strands of the paper towel can trap any size particle,
down to sub-micron, instead of acting like a sieve to pass through anything below a given
size (they like to avoid mentioning that the "sieve" stops anything above it's rated
size). However they never explained why the filters don't clog up if they are indeed
trapping particles, or why particles can't become dislodged and re-enter the system.
Also, the paper towel systems they were advocating were all "bypass" filters, ie on the
pressure regulator discharge rather than on the main loop, so they did not filter more
than a small percentage of the fuel being pumped. This is due to the fact that paper
towels can't withstand a very high differential pressure.

Fresh Breezes- Doug King


 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules

Smilies are On
[IMG] code is Off
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Problem changing out my fuel pump Derek General 2 July 3rd 04 01:50 PM
Engine dies- Putters when trying to plane- engine under under heavy load Bora Cider General 4 May 18th 04 04:12 PM
Can a single 72 gal per hour fuel pump run two 392 cu inch motors? Scott Downey General 4 October 19th 03 09:28 PM
Inboard won't run above 2800 RPM John M Murphy General 2 August 18th 03 05:27 PM
Fuel pump to carbs fuel line replacement Bob General 5 July 29th 03 05:51 PM


All times are GMT +1. The time now is 08:45 PM.

Powered by vBulletin® Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 BoatBanter.com.
The comments are property of their posters.
 

About Us

"It's about Boats"

 

Copyright © 2017