Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
Ryk wrote in message . ..
On Thu, 16 Oct 2003 23:19:59 GMT, in message Jere Lull wrote: Parallax wrote: Although I have few elecrical gadgets to use power, I do worry about having enough juice to run my VHF and running lights and am also partial to having a small fan. Auto-pilot is also nice on long runs. So what happens if my batteries accidently get run down? Changing my mind: Best is two battery banks. Only draw from one at a time, but always charge both. Going that way would make me feel I was wasting the untouched bank. I have two identical deep discharge house batteries (came with the boat). Running on "All" minimizes the degree of discharge by spreading it across the batteries, but leaves me open to running down past engine starting capability. My solution is a "booster pack" -- a sealed, self contained battery unit with jumper cable clamps that can be used to jump start cars. Mine weighs about 10 pounds and cost about CDN$60, making it a way simpler and cheaper bit of insurance. Yes I know that a "better" solution would be a separate cranking battery and associated switching. Ryk I looked carefully before installing the used 2GM and didnt see any pawls for the hand crank to engage, maybe as a previous poster suggested thee is one beneath a cover. I had serious trouble hand starting the 1GM as I just cannot get sufficient hand torque in the odd position I have to be in on my 28' S2. Its just damned awkward. I have considered drilling a hole thru the engine compartment bulkhead and making a crank extension so I can hand crank from the main cabin but gave up that idea when I installed the 2GM. Is this still feasible? Another idea for a prop generator. Voltage should be directly to speed.....so, who really needs a knotlog? |
#2
![]() |
|||
|
|||
![]()
I looked carefully before installing the used 2GM and didnt see any
pawls for the hand crank to engage, maybe as a previous poster suggested thee is one beneath a cover. I had serious trouble hand starting the 1GM as I just cannot get sufficient hand torque in the odd position I have to be in on my 28' S2. Its just damned awkward. I have considered drilling a hole thru the engine compartment bulkhead and making a crank extension so I can hand crank from the main cabin but gave up that idea when I installed the 2GM. Is this still feasible? The hand crank on my 2GM (ca 1983) fits on the end of the crankshaft pulley using a very simple arrangement of pawls. It's a somewhat awkward arrangement that requires the removal of the bulkhead to give room to swing the handle. The bigger problem is that, so far, I haven't been able to start it by hand. Despite having started similar-sized Lister diesels many times (albeit, quite a while ago) the 2GM still defeats me -- as soon as I slip the decompressor over the engine just stops, no matter how hard and fast I'm cranking. Perhaps it would work better if there were a second person available to operate the decompressor. The answer to this seems to be the portable booster battery already suggested. Giles Morris |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
Boat fell off trailer | General | |||
Habbi's gearcase full of water | General | |||
Harry's lobster boat? | General | |||
NEW Boat Profit Margins | General | |||
"The SEARCH" redux (long, as usual) | Cruising |