Home |
Search |
Today's Posts |
#18
![]()
posted to rec.boats.cruising
|
|||
|
|||
![]()
Peter Wiley wrote:
Depends. Is this going to be water cooled or air cooled? If water cooled, sea water or fresh water with radiator or via heat exchanger? Air cooled. I'm assuming air cooled as this is simplest for an engine. However, it may be noisy and need access to ventilation so belowdecks may not be ideal. The noise will be minimized since we can optimize the induction/exhaust system for one fundamental frequency and amplitude. However, you are right that it will make noise and require ventilation. I am particularly concerned about exhaust gases. A built-in system would almost certainly be more expensive to design and support, so we'd need to see sufficient demand to justify it. My preference would be for an integral tank that gravity-feeds the engine. This is simplest and therefore cheapest. You can always use it as a day tank and fill via dedicated line from the main tank, or rig up a float switch to kick in a pump. Does the higher profile of a gravity-fed system matter to you? Where would you envision operating such a system on your boat? Thanks for the feedback. -- Chuck Cox - SynchroSystems - Synchro.com , my email is politician-proof, just remove the PORK |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
How to Start an Outboard Motor Without Actually Starting It? | General | |||
Diesel starting problems | Cruising | |||
yanmar -ysb 1974 engine- poor starting | Cruising |