BoatBanter.com - Rigging cutter question

Page 3 of 3

Show 40 post(s) from this thread on one page

BoatBanter.com (https://www.boatbanter.com/)

- Cruising (https://www.boatbanter.com/cruising/)

- - Rigging cutter question (https://www.boatbanter.com/cruising/48528-rigging-cutter-question.html)

Terry Spragg

September 16th 05 04:55 PM

wrote:
Cut the hasp, they're generally a lot lighter duty than a
padlock. Dremel tools with fibre reinforced cut off wheels
will go through thin s.s. like butter.

I second the Dremel tool proposal, very efficient in my experience and
a useful tool for many other purposes, just be careful to wear safety
glasses.

Since I have the dubious benefit of a dismasting experience, my
recommendation for shedding the rigging quickly is to knock out the
clevis pins with a drift pin and hammer. It's much quicker than
cutting unless you have one of the explosive gizmos, and can use it
properly in adverse conditions.

Cutting rigging is not often required. Good vice grips and a knife
should do it.

When I was dismasted in a rough race, a tow was close, and no need
of panic to unburden the boat. Depending on contitions, it is
better to salvage the rig. The only damaged part on mine was the
mast extrusion, crushed at the spreaders, folded in half, because of
no compression tube on the spreader bolt inside. We even saved all
the sails and windex. There was temptation to chuck it all, but only
for a moment. If I had had to pick out the round wire clevis locks,
a pair of pliers or a fid would have been fastest, if fingers were
too stiff.

Terry K

Brian Whatcott

September 17th 05 05:26 PM

On Wed, 14 Sep 2005 10:32:06 GMT, "Roger Long"
wrote:

I'm locked out of my boat and have to cut the small pad lock off the
companionway.

If I invest in a bolt cutter, will it be useful as emergency gear in
case of a dismasting or do I need a different tool to cut S.S. rigging
wire quickly?

Bolt cutters make handy dandy wire ferrule crimpers, if a circular
bite is ground in the jaws.
They will cut cable, though I think the most prefered device looks
like a branch clippe on steroids with its short scimitar shaped
scissor jaws.

Brian Whatcott Altus OK
p.s. Should you be hand-wringing about a device that can cost $15 or
$20?

All times are GMT +1. The time now is 03:29 PM.

Page 3 of 3

Show 40 post(s) from this thread on one page