"Ken Heaton" wrote in message
news:chHee.69029$3V3.30177@edtnps89...
Comments below:
"boatgeek" wrote in message
oups.com...


I purchased one of these at a boat show (the only boat show I ever went to,
cause I got free tickets).

The demonstrations looked impressive and I purchased one with a roll of
wire. However, every time I want to use it, I find that it take too much
room to operate the twist tool and then bend the wire ends back ~180
degrees. Most engine and plumbing hoses don't offer this room.

I still keep it around but when ever there is a job that it might work on, I
find the regular hose clamps before I could find this tool and coil of wire.

Save your money.. Just another boat show "Slicer/Dicer".

--
My experience and opinion, FWIW

--
Steve
s/v Good Intentions