Home |
Search |
Today's Posts |
#13
![]() |
|||
|
|||
![]() "Dag Stenberg" wrote in message ... Dave wrote: On 18 Jan 2005 09:00:27 GMT, "Dag Stenberg" said: Another thing is, if you leave the mast up, you have to loosen the stays and shrouds anyway to prevent the stress on the hull from the shortening of wire in cold, so the additional nuisance of taking the whole thing out is not so big. How does the coefficient of expansion of aluminum compare to the coefficient of expansion of stainless wire? Good point! I found the following values (in m/m.K) from different sources: Al 23.5 E-6 Al 23.7 E-6 Steel 12 E-6 Al 22.2 E-6 Steel 13.0 E-6 that last source Stainless steel (304) 17.3 Stainless steel (310) 14.4 Stainless steel (316) 16.0 "The thermal expansion coefficient of aluminum near room temperature is about twice that of steel (the exact values depend on the type of aluminum and the type of steel, but for most types it's around 24 ppm per deg C for aluminum and 13 ppm per deg C for steel)" OK, so we'll believe that pure aluminium has nearly double heat expansion compared to stainless steel. Aluminium alloy 6063 T6: 22 E-6, Stainless steel (306) 17 E-6 Aluminium alloys (LM 25) 22 E-6 (6061) 24 E-6 (6082) 23 E-6 So we can still believe that aluminium alloys have much greater thermal expansion than even stainless steel. Where does that put us? I suppose one can then argue, that when it gets colder, the aluminium mast shortens more than the stainless steel shrouds, so those should actually loosen. Apparently I have been misled earlier by incomplete information.... This jives with what I have observed. Not so much that shrouds appeared to be loose, but I have noticed occationally that forestays and backstays appear a bit slack. I chauked this up to the fact that to be hauled with a Travelift one often has to release either the backstay or forestay to fit into the Travelift without hitting the crossbar. Once blocked, I assumed that the fore or backstay was not tightened as it would be for normal operation. Dag Stenberg Glad to learn something new and useful. Doug s/v Callista |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
tyvek (long) | Boat Building | |||
Mast Rake and Mast Bend | ASA | |||
Mast Wedges | ASA | |||
What's with mast wedges. | ASA | |||
Mast down (long) | ASA |