Home |
Search |
Today's Posts |
#3
![]() |
|||
|
|||
![]()
1/4" Starboard?
Wally wrote: I'm replacing the cockpit instruments (wind dir, speed, knot etc) in my sailboat and of course the holes are different. The original ones were cut right thru the cockpit combing gelcoat/glass - so have some big holes I can't use. The solution seems to be an overlay face panel - but what material - - not teak - too hard to keep up, - lexan/acrylic - starts to look bad after some years, - electropolished stainless - but what finish - don't want a mirror - aluminium anodized - maybe - hard to find good anod in So Cal? Any other suggestions. It needs to be about 30" x 7" -- Glenn Ashmore I'm building a 45' cutter in strip/composite. Watch my progress (or lack there of) at: http://www.rutuonline.com Shameless Commercial Division: http://www.spade-anchor-us.com |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
New instrument panel material | Boat Building | |||
( OT ) Why Bush didn't want a 9/11 panel | General | |||
( OT ) Probing the intelligence panel | General | |||
Would like to purchase a boat instrument panel | General | |||
Mounting pad for a large outboard motor - what material should it be made from? | Boat Building |