Home |
Search |
Today's Posts |
#7
![]() |
|||
|
|||
![]()
Back while an indentured servant to Uncle Sam, we polished an unpained metal
deck with unsweetened lemon drink powder and water using a Navy issue floor buffer. Sunglasses were recommended for viewing! :-) Ah, those military minds! "Keith" wrote in message ... Are you thinking about Imron? I've had reasonable success on brass bells with about 10 coats of clear polyurethane, but they didn't have lines rubbing against them all the time. I think that's what you're going to find is the real problem. Personally, on the bell I have now, I polish once a week with 3M's metal restorer and polish, which is like Flitz, etc. It's easier than trying to remove all those coats of finish after about a year, when it'll start tarnishing anyway. BTW, best way to get rid of really bad tarnishing on brass or bronze is to mix up 1 tablespoon of Citric acid (sour salt) per cup of hot water with a couple of drops of dish detergent as a wetting agent. Soak until it turns red. This will polish off easily, leaving you with some nice clean metal. -- Keith __ "A whim, once watered with imagination, becomes a dream and the best time to take your first step toward a dream is always yesterday; the worst time: tomorrow. Our best compromise is today." - Alvah Simon "Chris" wrote in message m... Hello and thank you in advance for your suggestions. I'm in the process of refinishing my boat. The exterior Port lights and fairleads are of solid bronze. I'm going to sand and polish to a bright finish and need to coat with a urethane, or some other durable product that will protect the polished finish and keep all gleaming and not turning green. I once coated with a two part DuPont product (forget the name) and it lasted for a reasonable time. I'm aware that there are new products out there that will under these harsh conditions guarantee a ten year protection but as yet have not located the company or product. Again this is an exterior project, often awash in sea water for days, stepped on and lines rubbing constantly. Any suggestions besides letting turn green and brasso every other week??? |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
exterior polished bronze coating??? | General | |||
exterior polished bronze coating??? | Boat Building | |||
Barrier Coating a fiberglass hull.... | Boat Building | |||
Tonval Bronze or Not? | Boat Building |