| Home |
| Search |
| Today's Posts |
|
|
|
#1
|
|||
|
|||
|
If the tank is about 20 years old, I suggest you change it. This is a waist
tank, you do not want it to leak! Listed below is a list of links you should checkout and read the FAQ and technical info. http://www.raritaneng.com/ http://www.oceanlinkinc.com/sanitation/index.asp http://www.groco.net/ http://www.trioniccorp.com/ "Cindy Ballreich" wrote in message ... Our holding tank is about 10 gallons and is located under the starboard settee. The connection for the vent hose is at the forward end of the tank. The hose runs back to an outlet about 3 feet aft and 2 feet above the tank. This gives a rather curvy, mostly horizontal hose run of about 6 feet. Air can enter and leave the tank for filling and emptying, but there isn't any real "air circulation" to prevent odors. It looks like there might be room to put a new connection at the aft corner of the tank which would shorten the hose run by 2.5 to 3 feet. The tank is fiberglass or some kind of very hard plastic. (It's been painted so it's difficult to tell what it's made from.) We think the tank is probably 20 years old and was custom made for the boat when it was built. The vent hose appears to be 1/2 inch ID. So here are my questions: 1. Would shortening the hose by this amount make any real difference in the air circulation? 2. Would modifying the tank cause any problems with its structural integrity? 3. Assuming the answer to 1 is "yes" and 2 is "no", how should we go about adding the new connector and removing the old one? Thanks Cindy |
|
#2
|
|||
|
|||
|
SBC wrote:
If the tank is about 20 years old, I suggest you change it. This is a waist tank, you do not want it to leak! Listed below is a list of links you should checkout and read the FAQ and technical info. Not necessarily...the older tanks are often a lot more durable than anything made today...many were made of extra thick-walled cross-linked poly, whereas most water and waste tanks today are made of relatively thin--1/4" or even less--low density linear poly. In fact, the holding tank was the only part of the sanitation system I didn't replace on my own 20 yr old "project boat"...it was so thick I suspect it would only bounce if dropped off a cliff. That tank will last at least as long as the hull, if not even longer. -- Peggie ---------- Peggie Hall Specializing in marine sanitation since 1987 Author "Get Rid of Boat Odors - A Guide To Marine Sanitation Systems and Other Sources of Aggravation and Odor" http://69.20.93.241/store/customer/p...40&cat=&page=1 |
| Reply |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| holding tank vents | Cruising | |||
| Belt and suspenders on holding tank | Cruising | |||
| Holding tank cradlle | Boat Building | |||
| Clogged waste tank vent | General | |||