Home |
Search |
Today's Posts |
#1
posted to rec.boats.building
|
|||
|
|||
Eyebrow making question
I am planning on replacing the eyebrow trim on my 35' sloop. The trim
needs to have a "S" curve in it, where it follows the lines of the cabin trunk. When making this section, is it usually made from a wide board, or from a bent piece of the trim. If so, what is the best method of bending Teak? Also, the orig eyebrow was so weathered and had been sanded a lot, that it's hard to figure the orig width and thickness. Any suggestions on the size to make it? Thanks in advance |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Mold Making | Boat Building | |||
making a rudder - this may be a stupid question but......... | Boat Building | |||
Making my own VHF antenna | Electronics | |||
Another war in the making | ASA | |||
Honda making Oil (again) | General |