Home |
Search |
Today's Posts |
#1
posted to rec.boats.building
|
|||
|
|||
Repainting fiberglass
I recently saw how my buddy repainted the sides of his boat with a white
fiberglass paint, using a brush. It did not look half bad from afar, but up close, you could see the brush strokes. Can this paint go on smoother with a spraying application, and will it look almost professionally done? I suppose you need a compressor to spray paint and do lots of masking off of the bright work and wood trim. This is for my topsides where I also have some gray non-skid areas. I assume you can paint those separately and being a flat finish, don't require as much care in application. Sherwin D. |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
Largest Piece Or Smallest Piece First When Laying Fiberglass Cloth Over a Tapered Edge? | Boat Building | |||
Epoxy or Polyester for Fixing Rotten Core on Deck? | Boat Building | |||
So where is...................... | General | |||
Fiberglass loss of strength | Cruising | |||
Fiberglass Hull Repair | Boat Building |