Home |
Search |
Today's Posts |
|
#1
![]() |
|||
|
|||
![]()
You can get an oilless compressor NOTE OILLESS and 50-60 ft of air
breathing hose and a regular scuba regulator. You need about 100 psi to run a low pressure - mouth regulator. A friend just did this with a small 120 vac compressor - it is just a little too small and it gets hard to breath down at the 6' bottom of his keel. The comp was about $100, the mouth reg will be maybe $100+ - look for all this stuff on eBay. I have a 50' hose that I use on my regular scuba tank, hi pressure and lo pressure regulators - the extension hose goes between the hi press reg on the tank and the lo pres regulator in the mouth. Biggest issue for any of these is getting the connections to work - threads - sizes, etc. Make sure that they all fit together before you buy anything. On Wed, 30 Jun 2004 17:35:00 GMT, wrote: I'd like to clean the bottom of my boat, while it's in the water. Is there a fairly easy and economical way of breathing while a few feet below the surface? A snorkle won't work because I'll be going under a houseboat, but am wondering if a hose could be made to work, or maybe a larger piece of tubing with a hose attached so it's small enough to be held in your mouth. Or something...? |
#2
![]() |
|||
|
|||
![]()
100 PSI isn't enough. The intermediate pressure in a typical SCUBA
system is set at 140-160 PSI. -- Chuck Tribolet http://www.almaden.ibm.com/cs/people/triblet Silicon Valley: STILL the best day job in the world. "Ace-high" wrote in message ... You can get an oilless compressor NOTE OILLESS and 50-60 ft of air breathing hose and a regular scuba regulator. You need about 100 psi to run a low pressure - mouth regulator. A friend just did this with a small 120 vac compressor - it is just a little too small and it gets hard to breath down at the 6' bottom of his keel. The comp was about $100, the mouth reg will be maybe $100+ - look for all this stuff on eBay. I have a 50' hose that I use on my regular scuba tank, hi pressure and lo pressure regulators - the extension hose goes between the hi press reg on the tank and the lo pres regulator in the mouth. Biggest issue for any of these is getting the connections to work - threads - sizes, etc. Make sure that they all fit together before you buy anything. On Wed, 30 Jun 2004 17:35:00 GMT, wrote: I'd like to clean the bottom of my boat, while it's in the water. Is there a fairly easy and economical way of breathing while a few feet below the surface? A snorkle won't work because I'll be going under a houseboat, but am wondering if a hose could be made to work, or maybe a larger piece of tubing with a hose attached so it's small enough to be held in your mouth. Or something...? |
#3
![]() |
|||
|
|||
![]()
Ace-high wrote:
You can get an oilless compressor NOTE OILLESS and 50-60 ft of air breathing hose and a regular scuba regulator. You need about 100 psi to run a low pressure - mouth regulator. A friend just did this with a small 120 vac compressor - it is just a little too small and it gets hard to breath down at the 6' bottom of his keel. The comp was about $100, the mouth reg will be maybe $100+ - look for all this stuff on eBay. I have a 50' hose that I use on my regular scuba tank, hi pressure and lo pressure regulators - the extension hose goes between the hi press reg on the tank and the lo pres regulator in the mouth. Biggest issue for any of these is getting the connections to work - threads - sizes, etc. Make sure that they all fit together before you buy anything. Apparently this is right & works pretty well, no tank fills & no rip off BS from the dive fraternity:-). The advantage being you can't get too deep because the little oiless compressors just can't supply the air. The only caution is make sure you install a one way valve in the supply line, as close as reasonable to the mouth reg. or use a specific hooker unit mouth reg (they have an extra valve built in). The risk is that if there's a hose failure at the surface your lungs will be exposed to atm pressure while your chest is subject to some psi, apparently your tongue can suffer if no valve is fitted. K On Wed, 30 Jun 2004 17:35:00 GMT, wrote: I'd like to clean the bottom of my boat, while it's in the water. Is there a fairly easy and economical way of breathing while a few feet below the surface? A snorkle won't work because I'll be going under a houseboat, but am wondering if a hose could be made to work, or maybe a larger piece of tubing with a hose attached so it's small enough to be held in your mouth. Or something...? |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Forum | |||
OT Hanoi John Kerry | General | |||
offshore fishing | General | |||
Where to find ramp stories? | General | |||
Dealing with a boat fire, checking for a common cause | General | |||
Repost from Merc group | General |