Tailgunner wrote:
Brian Nystrom wrote:

Tailgunner wrote:

Anybody use this in a marine environment? How does it hold up? I'm
using it for a leaning post seat covered in vinyl.


Ethafoam is not closed-cell and depending on the density you use, it
can absorb quite a bit of water. The lower the density, the more this
is an issue. The 2# and to some degree the 4# density are not well
suited to a wet environment. The heavier 6# and 9# densities don't
absorb as much. The difference is due to the smaller pores on the
denser foams.


Interesting. It's stamped "Ethafoam" on the side. It truly does appear
to be closed cell, but I have been wrong before, just ask the wife.

I'll take a test piece and soak and see what happens.

It's expanded polyethylene foam. Most of the cells are not
interconnected, but enough are to pose water absorption issues. The
large cells in the lighter foams are more likely to have substantial
connections than the smaller cells in the denser foams. It also has
rather low abrasion resistance and it will compress permanently if you
put pressure on it for an extended period of time. It's primarily used
as disposable/sacrificial packaging, similar to the way Styrofoam is
used, except that Ethaboam can be used to protect much heavier objects.