Home |
Search |
Today's Posts |
#1
|
|||
|
|||
Make GRP panels for canoe
Hi all,
I'm interested in building a canadian canoe for myself and my daughter to use. I have already built a small rowing boat using stitch and glue many years ago, but want to try something different. What I was thinking is to pre-make flat GRP panels (gelcoated on one side) and then build the canoe in a stitch and glue type method with these. I'd probably use polyester resin for the panels and tape together using epoxy. This is to help reduce the cost as I've not found epoxy resin to be all that cheap in the UK. So, with this in mind, how many layers of matt would be needed for the panel. Too many and it won't easily bend and I guess too few would leave it weak. Also, how do you determine the quantity of resin needed based on the sq.ft of the project? Any advice welcome. Thanks, Mark |
#2
|
|||
|
|||
) writes: What I was thinking is to pre-make flat GRP panels (gelcoated on one side) and then build the canoe in a stitch and glue type method with these. yes, it can be done. TF Jones writes about building a plywood skiff design (16 ft Dobler on his website www.jonesboats.com) that way. however, the result will be much heavier than doing the same thing in plywood. he laid up the GRP panels on masonite to get a smooth surface on the outside of the boat. I think he used wax to keep the resin from sticking. He put the panels together with polyester, spreading a thickened, uncatalyzed poylester filet, then covering with strips of fibreglass cloth saturated and "wetted out" with catalysed polyester resin. When I've put catalysed polyester over uncatalyzed it has taken overnight to cure through. -- ------------------------------------------------------------------------------ William R Watt National Capital FreeNet Ottawa's free community network homepage: www.ncf.ca/~ag384/top.htm warning: non-FreeNet email must have "notspam" in subject or it's returned |
#3
|
|||
|
|||
Hi,
That's great thanks. I was thinking of using melomine (sp?) as the base and even building basic moulds of exactly the correct size to enable a more rapid build. I'll look into this further. Cheers, Mark |
#4
|
|||
|
|||
Hi Arnold,
Many thanks for the information. I haven't seen blockboard for a long while in the UK, but I dare say that a decent DIY shop will sell it. I've been doing some more research on this (on the web) and found that Richard Woods has used this technique and some of his catamarans are designed to use this method. I've asked Richard for more information so I hope this is forthcoming. http://www.evecom.nl/multihulls/mult...ldin.tekst.htm http://www.sailingcatamarans.com/gypsy.htm For the canoe, it is only the sides which need to curve to any degree, with the bottom being flat so I would hope to have more layers on the bottom. I'll laminate a few layers over the weekend to see if I can judge the amount required for strength whilst keeping some minimal flexibility. Thanks, Mark |
Reply |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
REQ: Crack for Maxsea V10 | Tall Ships | |||
Just How Safe Do You Feel? | General |