Home |
Search |
Today's Posts |
#7
|
|||
|
|||
I buy a lot of stuff from Harbor Freight, and with most of it, I'm quite
happy. I bought one of those right angle adapters and it is junk -- the gears don't mesh right and the chuck is similarly bad. Roger http://home.earthlink.net/~derbyrm "MMC" wrote in message ... Take a look at this: http://www.harborfreight.com/cpi/cta...emnumber=91767 Our local toll rental carries right angle drills. MMC "Chris" wrote in message oups.com... I saw at the Miami boat show a salesman demonstrating an adaptor that when attached to the drill you could adjust the angle of the drive more than just a 90 degree fitting. (Should have bought it) I need to drill into the coaming through heavy glass and tap into a metal backing plate and the bottom holes clearance is less that 11/2" above the deck. Any suggestions out there?? |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
NY Go Kart Endurance Racing - Arrive & Drive - No Experience Needed | General | |||
NY Go Kart Endurance Racing - Arrive & Drive - No Experience Needed | Power Boat Racing | |||
NY Go Kart Endurance Racing - No Experience Needed - Arrive & Drive | Cruising | |||
B&D 24v Firestarter Cordless Drill | ASA | |||
GAULEY FESTIVAL VOLUNTEERS NEEDED | General |