Home |
Search |
Today's Posts |
#2
|
|||
|
|||
Chris wrote:
I saw at the Miami boat show a salesman demonstrating an adaptor that when attached to the drill you could adjust the angle of the drive more than just a 90 degree fitting. (Should have bought it) I need to drill into the coaming through heavy glass and tap into a metal backing plate and the bottom holes clearance is less that 11/2" above the deck. Any suggestions out there?? Don't even think about tapping that backing plate. Thru drill it if you ever expect to get it apart again. Lew |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Forum | |||
NY Go Kart Endurance Racing - Arrive & Drive - No Experience Needed | General | |||
NY Go Kart Endurance Racing - Arrive & Drive - No Experience Needed | Power Boat Racing | |||
NY Go Kart Endurance Racing - No Experience Needed - Arrive & Drive | Cruising | |||
B&D 24v Firestarter Cordless Drill | ASA | |||
GAULEY FESTIVAL VOLUNTEERS NEEDED | General |