I purchased a 1987 Hunter 28.5 a while back and there was some pre-existing
damage to the port rub rail. I've been meaning to get it fixed for some
time, but I can't find a section that I can have welded on. Does anyone
out there know of a place where I can either get a 4' section of rail that
matches, or an entire replacement rail? Any help appreciated.

Since Hunter is still in business why not call them and if they won't sell you
a small section ask them who their supplier is.
S/V Express 30 "Ringmaster"
"No shirt, no skirt, full service"

http://www.tacometals.com/


On Fri, 14 May 2004 02:44:52 -0400, "Bill Farina"
wrote:

I purchased a 1987 Hunter 28.5 a while back and there was some pre-existing
damage to the port rub rail. I've been meaning to get it fixed for some
time, but I can't find a section that I can have welded on. Does anyone
out there know of a place where I can either get a 4' section of rail that
matches, or an entire replacement rail? Any help appreciated.

http://www.tacometals.com/


Yup. Of course Loco wouldn't know about Taco, unless it had a lot of cheese.

RB

Just a matter of too much time and a bandage on my hand(s)



On 14 May 2004 14:19:02 GMT, (Bobsprit) wrote:

http://www.tacometals.com/


Yup. Of course Loco wouldn't know about Taco, unless it had a lot of cheese.

RB

Yup. Of course Loco wouldn't know about Taco, unless it had a lot of
cheese.

I have a Taco catalog in my file cabinet dimwit. What's that got to do with my
suggestion to the poster?
S/V Express 30 "Ringmaster"
"No shirt, no skirt, full service"

I have a Taco catalog in my file cabinet dimwit.

Yes, right under your enchalada catalogue! Bwahahahahaha!

RB