Mr. Luddite wrote:
On 3/14/2014 11:18 AM, Wayne.B wrote:
On Fri, 14 Mar 2014 03:47:59 -0400, "Mr. Luddite"
wrote:


I got curious regarding the discussion of rinsing an outboard using the
garden hose flush port versus muffs on the water inlet so I did some
reading. I had a Yamaha 250 four stroke on one of my outboard boats
and seemed to remember reading something about it.

First of all, it is not recommended that the engine be run while
flushing using the flush port. Yamaha states that *if* your water
supply pressure is sufficient to generate a steady stream from the pee
hole, it's ok to run the engine while flushing at idle RPM and for no
longer than 15 minutes. If the flow is *not* sufficient to generate a
steady pee stream, Yamaha says to use muffs in addition to the flush
port if you want to run the engine.

The flush port injects water after the thermostat which will be closed
if the engine is not running. If somehow water can still get down to
the inlet passages and impeller, the impeller won't be turning (unless
the engine is running, in which case it would simply pump the water
back
in the opposite direction), so I don't see how it can be rinsed off.
The impeller would tend to seal off any water from running through it
with the engine not running.

So, I still question if using the flush port thing really does
anything
to rinse the water inlet and impeller, extending it's life.

Here's some collaborating information:

http://www.saltawayproducts.com/FlushPortPage.htm

===

I'm not convinced that rinsing the impeller does anything to extend
its life. They are essentially self flushing everytime you use the
engine. Sand and shells do not accumulate in the pump and have
already done their damage as they pass through. Pumps and impellers
are not harmed by salt water corrosion, unlike engine blocks,
manifolds, heads, risers, etc.


True. I think you can get salt deposits within the casing though that
harden and might cause premature wear on a rubber impeller, especially
if you boat in the ocean but trailer the boat home at the end of the
day. My point in this discussion was that using the flush fitting
doesn't necessarily mean you are flushing the inlet passages or
impeller area. The Yamaha outboard I had was equipped with the flush
out port but when I hauled the boat I always flushed it with a muff
over the leg inlet screens.




Yup. Better safe than sorry as they say.