In article ,
says...

On 2/9/13 4:17 PM, JustWaitAFrekinMinute wrote:
On 2/9/2013 3:33 PM, iBoaterer wrote:
In article ,
says...

On 2/9/2013 11:33 AM, iBoaterer wrote:
In article ,

says...

On 2/9/2013 10:06 AM, iBoaterer wrote:
In article ,

says...

On 2/9/2013 9:46 AM, iBoaterer wrote:
In article ,

says...

On 2/8/2013 8:38 PM, Salmonbait wrote:
On Fri, 08 Feb 2013 20:26:36 -0500, JustWaitAFrekinMinute
wrote:

On 2/8/2013 8:19 PM, BAR wrote:
In article ,
says...

Anyone have a better idea than this for a target stand to
take to the range?

Unassembled:
http://www.theboxotruth.com/images/e24-1.jpg

Assembled:
http://www.theboxotruth.com/images/e24-5.jpg

Looks like a pretty good target stand. You can fill the
bottom with
sande or water to keep it in place when there is a bit of wind.


If he fills sections of tube with something solid, or seals
the ends of
a couple of the base tubes with sand inside, he can break it
down and
carry it in his bag without filling and un-filling the base...

That's the plan. Small bag of mortar mix ought to work well.
I'll just fill the bottom 'feet', but
leave them unglued so I can disassemble them easily.


Salmonbait

--
'Name-calling'...the liberals' answer to a lost argument!

You know you live in a Country run by idiots if... You have to
have your
parents signature to go on a school field trip but not to get
an abortion.


The only issue I see is getting the mortar plugs to not shrink
when
setting and fall out.. Might have to put a screw or a dowel
through the
side of the pipe before or after setting the mortar??

Um, how about non-shrink grout.......


Just be sure to rough the surface of the pvc so the goo will form a
mechanical bond..

No need, non shrink actually expands somewhat, and has bonding
agents to
adhere even to smooth steel.


Thank you mr, engineer... but in the real world....

You stupid little twit!!! In the "real world" non-shrink mortar has
bonding agents to adhere to smooth surfaces. But, I know you are insane
and stupid so you won't listen. Would you like me to show you? If so,
then will you shut up?


Yeah, you are right.. Let's not spend the time to put a screw in there,
because "on paper" it will never fail.. LOL..

WTF would a screw do if it's going to shrink,

Holy crap, you are hopeless...



You're about the right height for a target stand. How much would you
charge to stand and hold a target?

That would be employment, and he's too lazy for that.