In article ,
says...

On 2/9/2013 3:33 PM, iBoaterer wrote:
In article ,
says...

On 2/9/2013 11:33 AM, iBoaterer wrote:
In article ,
says...

On 2/9/2013 10:06 AM, iBoaterer wrote:
In article ,
says...

On 2/9/2013 9:46 AM, iBoaterer wrote:
In article ,
says...

On 2/8/2013 8:38 PM, Salmonbait wrote:
On Fri, 08 Feb 2013 20:26:36 -0500, JustWaitAFrekinMinute wrote:

On 2/8/2013 8:19 PM, BAR wrote:
In article ,
says...

Anyone have a better idea than this for a target stand to take to the range?

Unassembled:
http://www.theboxotruth.com/images/e24-1.jpg

Assembled:
http://www.theboxotruth.com/images/e24-5.jpg

Looks like a pretty good target stand. You can fill the bottom with
sande or water to keep it in place when there is a bit of wind.


If he fills sections of tube with something solid, or seals the ends of
a couple of the base tubes with sand inside, he can break it down and
carry it in his bag without filling and un-filling the base...

That's the plan. Small bag of mortar mix ought to work well. I'll just fill the bottom 'feet', but
leave them unglued so I can disassemble them easily.


Salmonbait

--
'Name-calling'...the liberals' answer to a lost argument!

You know you live in a Country run by idiots if... You have to have your
parents signature to go on a school field trip but not to get an abortion.


The only issue I see is getting the mortar plugs to not shrink when
setting and fall out.. Might have to put a screw or a dowel through the
side of the pipe before or after setting the mortar??

Um, how about non-shrink grout.......


Just be sure to rough the surface of the pvc so the goo will form a
mechanical bond..

No need, non shrink actually expands somewhat, and has bonding agents to
adhere even to smooth steel.


Thank you mr, engineer... but in the real world....

You stupid little twit!!! In the "real world" non-shrink mortar has
bonding agents to adhere to smooth surfaces. But, I know you are insane
and stupid so you won't listen. Would you like me to show you? If so,
then will you shut up?


Yeah, you are right.. Let's not spend the time to put a screw in there,
because "on paper" it will never fail.. LOL..

WTF would a screw do if it's going to shrink,

Holy crap, you are hopeless...

I'm "hopeless" because you come up with a hairbrained idea? Gee, why did
you erase the rest of my post?