On Fri, 16 Apr 2004 12:03:04 +0100, Dennis Pogson wrote:

Sir Spamalot wrote:
This is the third installment of a (hopefully) short series of
re-wiring questions g.

I'm running a bundle of wires from the transom to the cockpit, along
the side of the hull up under the gunwhales. It's an old boat, and
there is no wireway, PVC, or other convenient means to keep the bundle
from moving around.

Since the sides of the hull are single-layer fiberglass, I was
thinking of using those stick-on cable tie mounts to fix the cabling
up under the gunwhale, but I don't think they are legal to use. I
think the current standards call for "real" stainless clamps with the
rubber chafe covering, like the ones Ancor makes. But, obviously, I
don't want to drill holes in the sides of the boat to mount the
stainless clamps with nut and bolt.

Any ideas that won't get me into dutch if the CG takes a look? How do
other manufacturers' do it?

TIA,
SS
If you have room, run a plastic tube the full length of the boat, and leave
enough room in the tube diameter to pull further wires through at some later
date. Fasten the tube in place with clips or epoxy to the inside of the
hull. We used toilet outlet tubing, but chandlers carry all sorts of tubing.
Once it it in place, it's easy to feed extra wires through when needed.

There is a flexible, split plastic tube made precisely for this purpose,
called "wire loom". You can bundle the cables in there and then fasten the
tube to the sides using whatever is handy. It is available at both auto
parts stores or marine stores. Guess which place is cheaper!
--

Larry
email is rapp at lmr dot com