Doug,
All circuit breakers are not designed to be used as switches. Actually
they aren't guaranteed to work more than once, but I've know them to work
many times after being tripped repeatedly. They do make circuit breakers
that are intended to be used as a switch, I believe they have an "S"
designation on the breaker. If I were replacing circuit breakers I'd get
GFCI (ground fault circuit interrupter). They're a bit more but around the
water it seems like a good investment.
Paul

"Doug Dotson" wrote in message
...
Waste of switches. Breakers make fine switches. Don't know where
Larry is coming from on this one (as usual). The problem with the
T1 breaker is it is not idiot proof. If you hold the breaker in the on
position it holds the circuit closed rather then interrupting again like a
normal magnetic breaker will. I believe that the older thermal breakers
always behaved this way but I'm not sure. In any case, only a moron
would hold a breaker closed, but then again there seems to be an
unlimited supply of morons on boats these days

Doug
s/v Callista

"Rusty O" wrote in message
hlink.net...
Mine doesn't. All loads are switched or controlled by other than the
circuit
breakers.

Rusty O