I had considered hydraulic and if I already had hydraulic on the engine, I
probably would reconsider it.

Originally I had planned on hydraulic for the anchor windlass but found the
Lewmar 1000 vertical and I'm now happy with that.

Also any hydraulic cylinder and hoses would be right in the cockpit since my
rudder is 'outboard' and no provision for an inboard cylinder.

Additionally, I would have to find or build some kinda electrical to
hydraulic control valve for the AP control head to operate.

After reading Glenns comments regarding the operating speed of the screw
drive, I went to the boat and did a test to determine the rate of travel of
the OEM (AH3000) linear drive. It is exactly 1 inch per min. with no load.
The unit I'm considering is 3/4 inch per min.. 25% slower, however since the
this unit has 3 times the thrust I could move the tiller attachment pin aft
an appropriate amount to increase the rudder stop to stop travel time and
still have the advantage of the increased dynamic and static load.

I'm going to contact the fellows at Surplus Center and see if I can get some
more spec. info on this unit. They have been very help full in the past.

I am however taking Glenns warnings into consideration and thanks for the
heads up.

Steve
s/v Good Intentions