On Mon, 7 Nov 2011 18:20:46 +0000, Boats
wrote:


I would drain the tank completely to be sure, it would be worth the
extra efforts.

Water being heavier then gasoline will be in the bottom of the tank.
The easiest method to remove it is the one you describe If you are
still worried add some alcohol to the gas tank. It will mix with the
water to make a combustible mixture that will burn in your engine with
no problems. Google "dry gas".



Tim;899270 Wrote:
On Oct 25, 6:39*am, Drifter wrote:-
On 10/24/2011 11:29 PM, Wayne.B wrote:








-
On Mon, 24 Oct 2011 12:18:31 -0700, -...@++.-- wrote:-
--
Recently my boat got pounded pretty good from behind by a bunch of
wind produced
waves. After that it didn't want to run because water got in the
breather for
the gas tank. I ran a line from a can of good gas and ran the engine
and it
cleared up and began running normally again. I got an electric fuel
pump and
attached it to the tank's fuel line and pumped out into portable cans.
To me, at
first it appeared to pump clean water, then it looked milky for a
while, then it
looked like clean gas. I pumped about 2 more gallons out of the 14+/-
gallon
tank after it began looking like good gas, and it still looked good so
I stopped
pumping. Is it safe to think the remaining gas is okay?--
-
Others here have given you good advice:-
-
1. *Best to empty and discard as much of the tank as possible (most
of
the water will be on the bottom and will slosh around when under way
and get remixed with fuel).-
-
2. *Racor makes a really excellent bulkhead mounted fuel filter. * It
is more expensive than the Sierra but worth it in my opinion. * The
Racor has a drain tap on the bottom so you can see if water is
accumulating in the filter bowl and get rid rid of it.-

Do they make glass bowl filters for inboard gas engines?-

Sure! most of the older farm tractors had them, but they screwed into
the base of the tank. I have seen some mountable in-line glass bowl
units, though
--

Cheers,

Bruce