Thanks for all the advise, but all I was looking for was the bed before
vs bed after decision. I've bedded a few hundred deck fittings in my
days, but this is the first time I have totally stripped and repainted a
deck.

Doug
s/v Callista

"Lew Hodgett" wrote in message
link.net...

"Matt" writes:

Since you asked for opinions ...

I would paint first, then reinstall the hardware.

Agree.

If there is a paint failure, it should not affect the hardware mounting.
Also, depending on the hardware, even taped, it will be awkward to
paint.

Agree.

With respect to reinstalling the hardwa

1. I would suggest using polysulfide for bedding, as it is an adhesive
and
a
sealant, ages well, remains moderately flexible, and is paintable.
Silicone is good except that the area and any 'mess' will likely never
hold
paint.
5200 will bond the hardware and will be very difficult to remove.

Silicone and 5200 definitely do not apply to this task.

Whichever bedding compound is used, do not fully tighten down the
hardware
until the bedding has (mostly) cured. A day later, tighten it down,
putting
final compression on the bedding.

Mask the area with tape then place the fitting over taped area and cut
around fitting with sharp knife.

Remove fitting and tape under fitting.

Bed fitting using the old finishing nail trick.

Use about an 8d finish nail spacing around the perimeter of the fitting at
1" intervals with head just inside the perimeter of the fitting pointing
out.

Bed fitting and snug up against nail heads, allowing time to cure a few
days, then remove finish nails, masking tape around fitting and snug
fitting
down.

Time for some brewskis.

HTH



--
Lew

S/A: Challenge, The Bullet Proof Boat, (Under Construction in the
Southland)
Visit: http://home.earthlink.net/~lewhodgett for Pictures