View Single Post
  #4   Report Post  
Doug Dotson
 
Posts: n/a
Default land anchor vs fluke anchor for anchors set directly on beach

My boat was on land all winter and it didn't move an inch even
without an anchor

Doug
s/v Callista

"John H" wrote in message
news
On 26 May 2004 10:24:14 -0700, (Laura) wrote:

We have a 200 Sea Ray Sundeck (deckboat/bowrider). I have a fluke
anchor. We are new to boating.

My question is whether or not a "land anchor" is useful or will the
fluke anchor work just as well for setting the anchor right on the
beach?

I have found two types of beach anchors 1) Ironwood Pacific Land
Anchor for around $40. This is a helix design and is 22" long (see
http://www.ironwoodpacific.com/products/landanchor.asp) and 2) "beach
spike" length ?. This is more of a straight spike design, so you just
drive it straight down. (sold by www.skilimited.com).

I assume a land anchor is a little bit easier to use? But then again,
if a fluke anchor works just fine when in the water, wouldn't a fluke
anchor be just fine when on dry land? I am a bit concerned about
having too much gear on the boat. I also only have one anchor, so
maybe having a land anchor as a backup would be a good idea?


I carry a Danforth on the bow for water anchoring, and a very small

Danforth for
beach anchoring. When at a beach, I'm usually using both anchors, one off

the
bow, the other off the stern.

Works great!


John H

On the 'Poco Loco' out of Deale, MD
on the beautiful Chesapeake Bay!