On Jul 11, 10:07*pm, Wayne B wrote:
On Mon, 11 Jul 2011 19:46:30 -0700 (PDT), Tim
wrote:









On Jul 11, 9:32*pm, Wayne B wrote:
On Mon, 11 Jul 2011 18:12:51 -0700 (PDT), Tim
wrote:

Anybody know where you can get something like this. Here in the USA?
And doesn't cost 3 arms and two legs?

http://boatseatboxes.com/

You might want to repost your question on "rec.boats.building".

There are still a few knowledgeable guys who check in there once in a
while.

I was thinking that you might be able to adapt a small dock box but
prices have gone through the roof for them. * Best bet is probably to
build something out of plywood if you or a buddy have cabinet making
skills.

Oh yeah, we can build them but I liked the idea of the pre-formed and
If could be found reasonable, I'd think that would be the ticket.

http://www.lasvegaspix.com/projects/...s/IMG_1953.jpg

the guy *did a stunning job on the Sleekcraft Executive, and here's
the final outcome of his cooler seat box.

Nice. *Is that Formica/laminate over plywood? *Only problem with that
is sharp corners, something I try to avoid.

I noticed that too. No, I have a router and can make the edges 'dull'
I wouldn't want anything sharp like that. That's an inexcusable
hazard.

Before we talked about modified sine wave inverters I was thinking one
side for a cooler and the other side for a microwave, inverter, or
battery etc, but I think that an opposite side would be best equipped
for tools, wire ties tape, spare prop etc.

You know, Wayne, the REAL necessities.

?;^ )