Hi Greg,

We had considered this, but the required RPMs are so high, we'd be
breaking shear pins left & right!

We think the improperly seated water tube and/or impeller pieces in
the tube is probably the problem.

Will try to blow it out/seat it next.

Thanks!

"Greg" wrote in message ...
I used to own one which did the same thing. A friend of mine who rebuilds
motorcycles and small engines checked it out and just increased the low rpms
enough to get better water flow. The engine rpm was too low.

"Heather Wilson" wrote in message
m...
Well, we tried the vinegar trick... let the motor run for a long time
(15-20 mins) in a big bucket of vinegar.

No change. Engine still runs fine at mid throttle, but doesn't seem
to cool at low rpms.

Impeller is fine... Any other ideas?

Thanks!

(Heather Wilson) wrote in message
om...
Hi Guys,

We replaced the impeller last fall. Before we replaced it, it wasn't
cooling too well. We think there is some salt buildup in the cooling
system. Our next move will be to run the motor in a bucket of
vinegar.

Thanks!

Matt Colie wrote in message
...
Heather,

You still have a water pump problem. Both of my Hondas stream at all
speeds (except when the old one had trashed an impellor). The fact
that
you it streams above idle, but not at idle is a faithful indication of
a
water pump problem.

Steam out of that port (or anywhere actually) is a bad sign.

If it stalled after a long time hot, it may well have been done some
damage. If the paint burned off anyplace - it is most likely damaged.

As another stated, if you -ever- ran the engine out of the water, the
pump is fried. The pump housing may also be damaged. At least you
better get the lower unit off and check the pump again.

Good Luck

Matt Colie A.Sloop "Bonne Ide'e" S2-7.9 #1 -now with a BF9.9 XLAS
Lifelong Waterman, Licensed Mariner and Perpetual Sailor



Heather Wilson wrote:

Hi,

We have the above identified outboard (1988 long shaft) on our 21'
trailer sailor. Bought 2 years ago from a from a fresh water sailor
(lake Ontario), and we sail on the Chesapeake (brackish). We flush
the motor after a sail about 50% of the time.

We replaced the impeller (disintegrated) last year, and the
thermostat
this year. Did not note any obstructions in the observable coolant
passages.

The motor starts on the first pull, and seems to run fine. The
problem is that the cooling water indicator port (on the frame) only
streams water at ~1000rpm and above; below which it just steams.
During a stress test, we found the engine stalled after about 10
minutes of idling (& steaming).

Should the indicator port stream water at all rpms? Does the steam
indicate a cooling system problem?

Any guidance from someone with similar experience would be much
appreciated!

Thanks.




-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----