"WaIIy" wrote in message
...
On Sat, 17 Jul 2010 13:43:44 -0400, "Wilbur Hubbard"
wrote:

Now, with the GIP inside as a sleeve and with the boom bales machine
screwed
into the GIP (drilled and tapped into the GIP through the aluminum) the
system is much stronger than it originally was. Replacing the boom with
the
same extrusion would have been just another accident waiting to happen.
This
way the boom is stronger than ever and no hardware hassles such as
locating
another gooseneck and end fitting for a larger extrusion, etc. were
experienced.

You're such a freakin' hammer mechanic.


Simply not so! Like, for example, the aluminum boom extrusion in cross
section is egg shaped. Now how does one fill, strengthen and support an
egg-shaped cross section with a round pipe? Answer: One cannot. So what does
one do? One uses three galvanized pipes. One large one to fit the round end
of the egg shape and two smaller pipes to fit the pointed spaces that
remain. One chooses sizes that fit snugly but don't have to be hammered
home. That's not hammer mechanicing; that's engineering. The three pipes
where coated with slippery silicone rubber sealant before being slid home.


You have your pee-pee size little boat with a duct taped refridgerator,
etc and pretend to be a sailor.

Electrical tape, inch wide professional quality electrical tape! Again, the
refrigerator is repaired better than new. It took the original aluminum
tubing of the evaporator four years to corrode and develop pinholes whereby
the refrigerant leaked out. Now, with the tightly wrapped tubing completedly
sealed from the elements not only are the pinholes stopped from leaking but
further corrosion is also stopped.

Successful sailors are clever, enterprising and ingenious. We think out of
the box and never believe any lubberly ideas - ideas like if the
refrigerator breaks then throw it away and buy a new one. That's a workable
solution for lubberly dummies who have more money than brains but for we
frugal sailors who enjoy using our hands and brains, the better way to go is
to fix things and fix them better than they were to begin with.


I must admit you can be amusing once in a great while.

It's quite revealing as to the lubberly thought process when one of them
confuses initiative, creativity and enterprise with humor.


Wilbur Hubbard